LINK-BELT P3CL235N flange bearing 3 holes

LINK-BELT P3CL235N belongs to flange bearing 3 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P3CL235N and any equivalents.

For shafts that need to be tied into a metal frame or masonry wall, the LINK-BELT CL series flange Y-bearing unit combines a three-bolt flange housing with a self-aligning insert bearing. The three-bolt pattern holds the unit firmly and spreads the load over the mounting face, while the insert absorbs small alignment errors. Typical duties include conveying, ventilation, washing equipment and process lines where support is simple and service access matters.

Reading the CL code is straightforward once you know the blocks. The first letter, P, tells you the housing is a flange type. The digit after it gives the number of mounting bolts. Then CL identifies this Y-bearing unit family. The three-digit number that follows is the insert size, which sets the shaft diameter. A final N closes the reference and marks the housing construction variant. All codes in the group share the flange layout and differ only in insert size.

You will see these units on belt and chain conveyors, extractor fans and blowers, industrial laundry machines, mixers, bucket elevators and process lines in food, chemical and aggregate plants. They suit equipment where the shaft is carried on a plate or frame and a compact unit is needed to take radial load plus moderate thrust. MR Industrial Accessories LLC supplies this LINK-BELT line for both replacement work and new builds.

Selection starts with the shaft diameter. From there, confirm the flange bolt pattern: the bolt count and the center distance must line up with the structure you are mounting to. Match the insert sealing to the environment, since dust, water or washdown call for extra protection. During installation, seat the flange on a flat surface, tighten bolts in a cross pattern and check that the shaft turns freely. Lubricating the insert and aligning it carefully will extend the life of the assembly.

Flange Y-bearing units can be swapped between manufacturers by shaft number and flange configuration, but there is no direct cross-reference because each brand uses its own nomenclature. To replace an existing unit, send the code stamped on the part, or the shaft and bolt pattern dimensions, and we will identify the compatible alternative in our line.

If you already have the housing part number, send it by WhatsApp or email and we will reply promptly with a quote. We can also assist if you are designing new equipment and need to settle on the right flange and insert size for your shaft. With the model or main dimensions, we will help you order correctly and avoid unnecessary downtime.