LINK-BELT FX3S2E36E flange bearing 2 holes
- Brand
- LINK-BELT
- Category
- Bearing housings
- Subcategory
- Bearing housings
- Series
- 200
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
LINK-BELT FX3S2E36E belongs to flange bearing 2 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for FX3S2E36E and any equivalents.
LINK-BELT 200 series flange bearing housings are mounted units that come with a bearing already installed. They hold a rotating shaft to a wall, chassis or structure, with the shaft sitting at a right angle to the mounting face. Two anchor points give a firm hold. MR Industrial Accessories LLC supplies this line for power transmission and conveying equipment.
The part number tells you what you are holding. Letters and digits mix to show unit type, shaft size and sealing method. Take FX3S2E20E, FX3S2E26E, FX3S2E32E and FX3S2E36E: the two digits just before the last letter give the nominal diameter in inches. The S marks the housing style, and the closing E marks the seal arrangement. Read the code this way and you can pick the right replacement without guessing.
You will find these housings on belt conveyors, bucket elevators, mixers, agitators and process equipment where the shaft runs horizontally or vertically through a flange. Food, cement, grain and chemical plants use them where a tough unit that swaps out easily is needed. The two-bolt flange makes mounting to steelwork or masonry simple, and the built-in bearing takes radial loads plus some axial thrust.
Selection starts with shaft diameter, load type and the surrounding conditions. Sealing deserves close attention: in dusty or wet areas, check the seal style and whether labyrinths are fitted. Use the lubricant specified for the built-in bearing. When mounting, line the flange up with the shaft to avoid added loads. Bolts that are uneven or too tight can warp the housing and cut its working life.
Flange housings from different brands often interchange when they share the same basic nomenclature, but housing material, seal type or bearing tolerance can differ. For a replacement, send the complete part number and shaft dimensions. MR Industrial Accessories LLC will identify the compatible option so your equipment stays in service.
Have the housing part number or the shaft size? Send it by WhatsApp or email to MR Industrial Accessories LLC and we will quote it promptly. We can also help with lubrication and mounting advice so the unit performs well.
Dimensions
- Bore
- 2 1/4 in
Frequently asked questions
- How do I know what size of LINK-BELT flange housing I need?
- Measure the shaft diameter at the bearing seat. In the designation, the two digits before the final letter give that size in inches. If unsure, send the full part number or the shaft size and we will quote the matching unit.
- Can they be mounted in any position?
- Yes. The two-bolt flange lets you fasten it to a wall, chassis or structure, with the shaft perpendicular to the mounting plane. Keep the surface flat and tighten the bolts evenly so the housing is not distorted.
- What lubrication does this type of housing use?
- The built-in bearing is greased at the factory, but in service follow the manufacturer's instructions for grease type and relubrication interval. In dusty or damp environments, check the sealing and use a grease suited to those conditions.