LINK-BELT FEB22419H flange bearing 3 holes

LINK-BELT FEB22419H belongs to flange bearing 3 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for FEB22419H and any equivalents.

For plants that need to secure a rotating shaft to a flat surface, the Link-Belt FEB H series offers a three-bolt flange housing that carries a mounted bearing. These units appear in conveyors, mixers, elevators and similar process equipment where a compact, front-mounting solution is required. MR Industrial Accessories supplies this line and can help you match the right unit to your shaft diameter and load conditions.

Reading the FEB H code helps you order the correct replacement. The letters FEB point to the flange housing family, while the following number captures the size and series of the housed bearing. In the examples shown, series B22400 and B22600 indicate medium-duty mounted units. The H at the end identifies the unit configuration within the line. To reorder, just give us the complete code from the nameplate or drawing.

You will find these housings in food and beverage operations, water treatment facilities, cement plants, feed lots and milling sites. They also serve belt and chain conveyors, bucket elevators, horizontal mixers, blowers and industrial washing equipment. The three-bolt flange makes anchoring to sheet metal or profile structures straightforward, and the mounted bearing tolerates misalignment better than a rigid one-piece housing.

Selection starts with the shaft diameter your equipment requires and the load type: radial, axial or combined. Confirm there is clearance for the three bolts and that the mounting surface is flat and clean. When installing, tighten the bolts in a crosswise, progressive pattern and verify shaft alignment before final torque. In dusty, wet or washdown environments, choose suitable sealing and monitor grease condition. Proper lubrication and periodic re-tightening help extend the life of the mounted bearing.

Flange mounted units come from various brands and lines, each with its own nomenclature. Interchangeability is not determined by shaft diameter alone: you must compare bolt hole spacing, flange diameter, center height and bearing locking type. We can point you to the alternative that matches those dimensions. For an older machine, sending a photo of the flange and shaft helps avoid errors.

MR Industrial Accessories supplies the Link-Belt line and manufactures split plummer block housings, ANSI roller chains and sheaves. To replace a housing from this series, message us on WhatsApp or email with the full code and shaft dimensions. We will quote the unit and, if needed, suggest a compatible alternative. We can also advise on sealing, lubrication and mounting so the unit performs under your plant conditions.