LINK-BELT F3Y212N flange bearing 3 holes
- Brand
- LINK-BELT
- Category
- Bearing housings
- Subcategory
- Bearing housings
- Series
- 200
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
LINK-BELT F3Y212N belongs to flange bearing 3 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for F3Y212N and any equivalents.
For equipment that needs a compact, three-point shaft support, the Link-Belt 200 series 3-bolt flange bearing bolts directly to a flat surface. It is a practical choice for conveyors, elevators, and process machinery where access is limited and the housing must stay rigid.
The part number for these units follows a logical sequence. The leading F stands for the 3-bolt flange style. The next digit gives the shaft size in inches. The letter Y marks the mounted bearing series, and the two digits after it indicate the 200 series. A final N denotes the locking method. For example, F3Y212N fits a 2-inch shaft, while F3Y222N is for the larger end of the range.
Typical installations include belt conveyors, bucket elevators, mixers, screens, and processing lines in food, cement, aggregate, and water treatment plants. The three-bolt design simplifies alignment on sheet metal frames and structural profiles, making it a good fit where a flat mounting face is available and only a few fasteners are desired.
Start selection with the shaft diameter and the load pattern: mostly radial for conveyors, with some axial thrust in screw conveyors and agitators. Match the seal to the environment—dust, washdown, or moisture will call for tighter protection. During installation, place the flange on a clean, flat surface, torque the three bolts in a crossing sequence, and confirm the shaft rotates without binding. Re-grease according to the operating cycle and grease specification.
When looking for an equivalent from another manufacturer, compare the shaft size, series, flange type, bolt hole spacing, center height, and locking style. Do not rely on the commercial part number alone. Avoid shimming or modifying the flange, as that can misalign the bearing. If you provide the dimensions or a drawing, we can help identify a compatible unit.
Send your part number or shaft measurement to MR Industrial Accessories LLC by WhatsApp or email, and we will quote the Link-Belt bearing you need. We can also advise on sealing, lubrication, and mounting so the support runs true and lasts.
Dimensions
- Bore
- 3/4 in
Frequently asked questions
- How do I determine which F3Y bearing I need?
- You need the shaft diameter, the mounted bearing series, and the flange type. The full F3Y part number specifies all of these. If you don't have the number, send the shaft size and flange hole spacing, and we will quote the correct unit.
- Can I replace this bearing with another brand?
- Yes, if the shaft diameter, series, number of bolt holes, center distance, and center height match. Interchangeability depends on those dimensions rather than the commercial part number. Provide the data and we will suggest a compatible alternative.
- What should I check during installation?
- Mount the flange on a clean, flat surface, tighten the three bolts in a cross pattern, and make sure the shaft turns freely. Verify alignment and sealing for the operating environment. A warped or poorly supported flange will shorten bearing life.