LINK-BELT F3W2B08E flange bearing 3 holes

LINK-BELT F3W2B08E belongs to flange bearing 3 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for F3W2B08E and any equivalents.

This LINK-BELT series 200 3-bolt flange bracket is a mounted bearing unit that fastens to sheet metal or a structure at three points. It provides a rigid, front-mount support that keeps the shaft line fixed relative to the mounting surface. MR Industrial Accessories supplies this LINK-BELT line to customers across the United States and in several Latin American countries, and can help you match the bracket to your shaft diameter and load conditions.

The part number is built in blocks. In F3W2B08E, the F stands for the mounting flange and the 3 gives the number of fastening holes. The W identifies the housing series, while the B indicates the mounted bearing type. The two digits 08 correspond to the nominal shaft diameter, and the final E marks a sealing or configuration variant. Reading the full code removes any doubt about which bracket you are specifying.

You will find these brackets on belt and roller conveyors, bucket elevators, mixers, screens and other process equipment. They suit food, chemical and aggregate plants because they mount easily on folded sheet metal frames and allow bearing replacement without taking the structure apart. Centrifugal fans, pumps and transmission lines also use them where the support must sit flush against a vertical or horizontal face.

Selection depends on shaft diameter, load direction and the working environment. In dusty or humid areas, favor versions with reinforced sealing. Where misalignment is present, confirm that the bracket allows the needed play. During installation, rest the flange on a flat surface, tighten the three bolts evenly, and check shaft alignment before lubricating and starting up.

Flange brackets are offered under various brands and with equivalent nomenclatures. Interchangeability depends on the series, shaft diameter and fastening type, not on the part number alone. When replacing a unit, compare the critical dimensions of the flange and the housing. MR Industrial Accessories can point you to a compatible alternative from the lines we carry.

If you already know the bracket part number, send it by WhatsApp or email along with the shaft diameter or a photo of the nameplate. With that information, we will quote the LINK-BELT series 200 or the equivalent option that fits your equipment, and we will assist with sealing and lubrication choices.