LINK-BELT F3S210E flange bearing 3 holes
- Brand
- LINK-BELT
- Category
- Bearing housings
- Subcategory
- Bearing housings
- Series
- 200
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
LINK-BELT F3S210E belongs to flange bearing 3 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for F3S210E and any equivalents.
Link-Belt series 200 3-bolt flange housings are mounted bearing units in which a triangular flange housing carries an insert bearing. They support rotating shafts on flat surfaces, with the flange bolted straight to sheet metal or a frame. MR Industrial Accessories LLC supplies this line and helps you pick the right variant based on shaft diameter and locking method.
The part number is built in blocks. The leading F stands for a 3-bolt flange. The first digit after the F tells you the housing type or configuration. The S points to the insert bearing series. The next two digits give the nominal shaft diameter in sixteenths of an inch. The trailing E identifies the insert design, typically set screw or eccentric collar. Because of that, F3S210E and F3S211E are not interchangeable: the shaft size differs. Send the full part number and we will quote that exact variant.
Typical applications include belt conveyors, bucket elevators, mixers, rotary dryers and packaging lines. Plants in food processing, cement, grain handling and chemicals use them where a 3-bolt flange lets you mount on sheet metal profiles without machining. They also suit equipment where the shaft sits perpendicular to the mounting surface and the housing has to absorb small misalignments from assembly.
For selection, start with the shaft diameter, then choose the insert type: set screw, eccentric collar or taper adapter. The flange housing may be cast iron or stamped steel, depending on the series. When fitting, set the flange on a clean, flat surface, tighten the three bolts in a cross pattern and confirm the shaft turns freely. Lubricating the insert and sealing against dust and water are key to service life; in humid environments, extra protection is advisable.
On equivalences, series 200 3-bolt flange housings with insert bearings come from several brands, but flange dimensions and center height do not always line up between manufacturers. Do not trust the part number alone: compare shaft diameter, hole spacing and insert locking type. If you are replacing a Link-Belt, message us on WhatsApp with the part number F3S2xxE or a photo of the part and we will point you to a compatible alternative.
MR Industrial Accessories LLC supplies the Link-Belt line. If the part number you need is not listed, send the model or the shaft and flange dimensions and we will quote it promptly.
Dimensions
- Bore
- 5/8 in
Frequently asked questions
- How do I identify the flange housing I need?
- Check the part number stamped on the housing or insert. Link-Belt series 200 uses a number such as F3S2xxE, where the two middle digits give the shaft diameter. If you cannot read it, measure the shaft with a caliper and the distance between the flange holes.
- What is the difference between a 3-bolt flange housing and a 2-bolt one?
- The 3-bolt flange spreads loads better and mounts on thin sheet metal or profiles, while the 2-bolt type is used in simpler supports. The choice depends on available space and the rigidity the shaft needs.
- Are Link-Belt series 200 housings interchangeable with other brands?
- They can be, but not always. Flange dimensions, center height and insert type vary between manufacturers. Before replacing, compare shaft diameter, hole spacing and locking system. If in doubt, send us the data and we will advise you.