V-belt Gates XPB 1000
- Brand
- GATES
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- XPB
- Series
- Quad-Power 4
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
GATES XPB 1000 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for XPB 1000 and any equivalents.
This Gates Quad-Power 4 belt is a cogged narrow V-belt with an XPB profile and a 1000 mm length. Cogged narrow V-belts are common on industrial drives where space is tight and speeds are high, such as pumps, fans, and compressors. The cogged construction helps the belt run cooler and more flexibly than a standard wrapped belt.
To confirm fit, check the drive for the belt section and length. The XPB profile and 1000 mm length must match the old belt or the drive manufacturer's specification. If you are replacing a belt, read the marking on the back of the old belt and compare it to the XPB 1000. A belt that is too long or too short will not tension correctly and can damage the drive.
Inspect the drive before installing a new belt. Check the sheaves for wear, alignment, and any burrs that could cut the belt. Verify that the tension is set to the drive manufacturer's recommendation. On multi-belt drives, replace all belts at the same time to keep loads even and avoid premature failure of the new belt.
When you request a quote, send the part number XPB 1000 and the quantity you need. If you are unsure about the profile or length, send a photo of the old belt's marking and the drive nameplate. Our team can confirm the right belt or suggest an equivalent.
Dimensions
- Section
- XPB
- Length
- 1000mm
Frequently asked questions
- How do I confirm that the Gates XPB 1000 is the right belt for my drive?
- Check the old belt's marking for XPB and 1000 mm. Also verify the drive sheaves are designed for an XPB profile. If the marking is unreadable, measure the outside length and compare it to 1000 mm, but always confirm the profile.
- Can I replace just one belt on a multi-belt drive?
- No. On a drive with multiple belts, replace all belts at the same time. Mixing new and old belts can cause uneven tension and lead to premature failure.
- What information should I send with my quote request?
- Send the part number XPB 1000 and the quantity. If you are unsure, include a photo of the old belt's marking and the drive nameplate so we can confirm the correct belt.