V-belt Gates SPBP 8000
- Brand
- GATES
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPB
- Series
- Predator
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
GATES SPBP 8000 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPBP 8000 and any equivalents.
The Gates Predator SPBP 8000 is a narrow wedge V-belt with an SPB profile and an 8000 mm length. This page gives you the dimensions and the practical steps for matching it to the belt you are replacing.
Start by reading the marking on the back of the old belt. If it shows SPB and 8000 mm, the Gates Predator SPBP 8000 matches on profile and length. The belt has a top width of 16.3 mm, a height of 13 mm and a 40-degree angle, so check those values against the old belt when the marking is worn or missing.
Measure the old belt only when the marking cannot be read. Confirm the profile first, then the length, then the cross-section. A belt that is close in length but wrong in profile will not sit correctly in the pulley groove.
For a quote, send the part number SPBP 8000, the profile SPB, the length 8000 mm and the quantity. If the old belt carries a different number, send that number and the dimensions you measured. We carry Gates belts and can help confirm the right belt or suggest an equivalent.
Dimensions
- Section
- SPB
- Length
- 8000mm
Frequently asked questions
- How do I confirm the Gates Predator SPBP 8000 is the belt I need?
- Check the marking on the back of the old belt. The replacement must match the SPB profile and the 8000 mm length. If the marking is unreadable, measure the top width, height and angle and compare them with 16.3 mm, 13 mm and 40 degrees.
- What should I send to request a quote?
- Send the part number SPBP 8000, the profile SPB, the length 8000 mm and the quantity. If you are replacing a different belt, include the number on the old belt and any dimensions you measured.
- Can I replace just one belt on a multi-belt drive?
- On a drive with more than one belt, replace the full set so the belts share the load evenly. Use the same profile and length across the set, and confirm the SPB profile and 8000 mm length before ordering.