V-belt Gates SPB 3350 PowerBand
- Brand
- GATES
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPB
- Series
- Super HC PowerBand
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
GATES SPB 3350 PowerBand belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPB 3350 PowerBand and any equivalents.
The Gates SPB 3350 PowerBand is a banded V-belt in the Super HC PowerBand series, with a length of 3350 mm. Before you install it, take a few minutes to inspect the drive and sheaves. That step helps you get the full service life from the belt and avoids repeating the same failure.
Check each sheave groove for wear, rust, or debris. Worn grooves can let the belt sit too deep, which leads to slipping and heat. Confirm that the sheaves are aligned and that the grooves are clean and smooth. Also inspect the bearings and shaft for play, and verify that the drive is locked out before you begin.
Once the drive checks out, fit the new belt without forcing it over the sheave edges. Tension it according to your drive manufacturer's specification, then run the drive for a short time and recheck the tension. Because this is a banded V-belt, the ribs work as a set, so the belt must sit evenly in all grooves.
If you are replacing an existing belt, note the part number on the back: SPB 3350 PowerBand. That marking confirms the profile and length you need. Send that number to our team via WhatsApp or email, and we will help you confirm the right belt for your drive.
Dimensions
- Length
- 3350mm
Frequently asked questions
- How do I request a quote for the Gates SPB 3350 PowerBand?
- Send us the part number SPB 3350 PowerBand by WhatsApp or email. Our team will reply promptly to confirm the belt and provide a quote.
- What should I check on the drive before fitting this belt?
- Inspect the sheave grooves for wear or debris, verify alignment, and check bearings and shafts for play. Addressing these points before installation helps the belt run properly.
- Can you help if I am not sure this is the correct belt?
- Yes. Send the marking from your old belt, along with the drive details, and we will help you confirm the right belt or suggest an equivalent.