V-belt Gates SPB 2650 MN
- Brand
- GATES
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPB
- Series
- Super HC MN
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
GATES SPB 2650 MN belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPB 2650 MN and any equivalents.
The Gates SPB 2650 MN is a narrow wedge V-belt in the Super HC MN series with an SPB profile and a 2650 mm length. Before you install it, inspect the drive and sheaves so the new belt seats and wears correctly.
Check sheave grooves for wear, scoring, or embedded debris, and confirm the grooves match the SPB profile. Verify that shafts and sheaves are aligned and that the sheave grooves are clean and free of rust or burrs. Measure the old belt and compare the marking on its back to the SPB 2650 MN designation before ordering, so the replacement matches the drive.
The belt is 16.3 mm at the top width, 13 mm high, and has a 40 degree angle. Confirm these dimensions against the sheave groove and the drive layout. If the drive runs multiple belts, inspect every belt in the set and replace them together so the load stays even across the grooves.
When you request a quote, send the part number SPB 2650 MN and the quantity you need. If you are unsure whether this narrow wedge V-belt fits your drive, share the belt marking, the sheave groove profile, and the center distance, and the team can help confirm the right belt or suggest an equivalent.
Dimensions
- Section
- SPB
- Length
- 2650mm
Frequently asked questions
- What should I check on the drive before fitting this belt?
- Inspect the sheave grooves for wear, scoring, or debris, confirm the grooves match the SPB profile, and check shaft and sheave alignment. Clean the grooves and remove any rust or burrs before installing the belt.
- How do I identify the belt on the drive?
- Look for the marking on the back of the belt and compare it to the SPB 2650 MN part number. The belt has an SPB profile and a 2650 mm length, with a 16.3 mm top width, 13 mm height, and 40 degree angle.
- What information do you need for a quote?
- Send the part number SPB 2650 MN and the quantity you need by WhatsApp or email. If you are unsure about the fit, include the belt marking, the sheave groove profile, and the center distance so the team can help confirm the right belt.