V-belt Gates C 320
- Brand
- GATES
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- C
- Series
- Hi-Power II
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
GATES C 320 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for C 320 and any equivalents.
The Gates Hi-Power II C 320 is a classical V-belt with a C profile and a length of 8178.8 mm. To match it to the belt being replaced, read the full part number and profile marking on the back of the old belt.
Confirm that the old belt is marked C 320 and that the profile matches: C section, 22 mm top width, 14 mm height, 40° angle. Measure the outside length only if the marking is unreadable, and compare it with the 8178.8 mm length listed here. A belt with a different profile or length will not seat correctly in the pulley groove.
Inspect the drive before ordering. Check pulley grooves for wear, verify alignment, and look for oil or heat damage that may have caused the original belt to fail. If the drive runs multiple belts, replace them as a set so the load is shared evenly.
When you request a quote, send the part number C 320 and the brand Gates, along with the profile and length from the old belt if it differs. Our team replies promptly by WhatsApp or email and can confirm the correct belt or suggest an equivalent.
Dimensions
- Section
- C
- Length
- 8178.8mm
Frequently asked questions
- How do I identify the belt I need to replace?
- Read the marking on the back of the old belt. If it shows C 320, this Gates Hi-Power II belt matches that part number. Also confirm the profile: C section, 22 mm top width, 14 mm height, 40° angle.
- What measurements should I send with my quote request?
- Send the part number C 320, the brand Gates, and the profile and length from the old belt. If the marking is worn, measure the outside length and compare it with the 8178.8 mm length listed for this belt.
- Can you help if the old belt marking is unreadable?
- Yes. Send photos of the old belt and the pulley grooves, or provide the profile and measured length. We will confirm whether this C 320 belt is the correct match or suggest an equivalent.