V-belt Gates C 182
- Brand
- GATES
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- C
- Series
- Hi-Power II
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Other brands for this category
Ask us for alternatives. We check every equivalent against the part number and your application.
GATES and MITSUBOSHI: matching part numbers →GATES and STARK: matching part numbers →
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
GATES C 182 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for C 182 and any equivalents.
This Gates Hi-Power II C 182 is a classical V-belt with a C profile and a 4724.4 mm length. It is used on heavy-duty industrial drives where a wrapped classical V-belt is the specified replacement. Confirm the belt marking and drive dimensions before ordering.
The C profile gives this belt a 22 mm top width, 14 mm height and a 40° angle. Classical V-belts in this profile are common on large fans, pumps, compressors and process equipment. The Hi-Power II series is a wrapped construction intended for general industrial service.
To confirm fit, read the marking on the back of the old belt and measure the outside length. The replacement should match the C profile, the 4724.4 mm length and the 22 mm top width. Check the sheave groove for wear and make sure the belt seats correctly without bottoming out.
When replacing more than one belt on a drive, install a matched set so the load is shared evenly. Inspect sheaves for burrs, rust or worn grooves, and check alignment before tensioning. The same size is also listed under Mitsuboshi C 182 and Stark C 182.
Dimensions
- Section
- C
- Length
- 4724.4mm
Frequently asked questions
- How do I confirm this C 182 belt fits my drive?
- Read the belt marking on the old belt and compare it with the C profile and 4724.4 mm length. Measure the top width and check the sheave groove dimensions to ensure the belt seats properly.
- Can I replace just one belt on a multi-belt drive?
- On drives with multiple belts, replace the full set at the same time so all belts carry the load evenly. Mixing new and worn belts can cause uneven tension and premature failure.
- What information should I send for a quote?
- Send the part number C 182, the brand Gates, and the quantity you need. If you are unsure, include the old belt marking and the drive sheave details so we can help confirm the correct belt.