V-belt Gates A 200
- Brand
- GATES
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
- Series
- Hi-Power II
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
GATES A 200 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for A 200 and any equivalents.
The Gates Hi-Power II A 200 is a classical V-belt with an A profile and a 5130.8 mm length. It measures 13 mm across the top, 8 mm high, and has a 40° angle. We carry this belt for maintenance, engineering, and purchasing teams who need to match an existing drive.
To match this belt to the one being replaced, start with the marking on the old belt. The A profile and the 5130.8 mm length are the two dimensions that must agree, because a belt that is too short will not fit over the pulleys and one that is too long will not tension correctly. Check the top width of 13 mm and the height of 8 mm against the pulley groove; if the old belt is worn, these dimensions may be undersized and misleading, so compare with the drive's original specification whenever possible.
The 40° angle is the included angle of the belt cross-section. It is set to match the pulley groove so the belt wedges in and transmits load without slipping. If the angle or profile is wrong, the belt can ride too high or too low in the groove, which leads to heat, noise, and short belt life. Confirm that the replacement belt carries the same profile and angle before installation.
When you request a quote, send the part number A 200 and, if you have it, the old belt's marking. Our team can confirm the profile and length and help you identify the correct belt for your drive. If you are replacing more than one belt on a multi-belt drive, order the full set so all belts share the same dimensions and wear evenly.
Dimensions
- Section
- A
- Length
- 5130.8mm
Frequently asked questions
- What do I need to match this belt to the one I am replacing?
- Match the profile and length. This belt has an A profile and a 5130.8 mm length. Also check the top width of 13 mm, the height of 8 mm, and the 40° angle against your pulley groove and the old belt's marking.
- Can I use this belt if the old belt marking is worn off?
- Yes. Measure the drive's pulley grooves and the center distance to determine the required profile and length, or send us the drive details and we can help confirm the correct belt.
- Should I replace all belts on the drive at the same time?
- On a multi-belt drive, replace the full set at once. Belts that have run together wear to the same length, and mixing old and new belts can cause uneven loading and premature failure.