V-belt Gates 28x950
- Brand
- GATES
- Category
- Power transmission
- Subcategory
- V-belts
- Series
- Multi-Speed
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
GATES 28x950 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 28x950 and any equivalents.
A variable speed belt wears along its flanks, so the sheaves it runs in matter as much as the belt itself. This Gates Multi-Speed belt is listed as size 28x950 with a length of 950 mm. Before you fit it, inspect the drive so the new belt has clean, true surfaces to run on.
Check both sheaves for grooves, ridges, scoring and polish marks on the flanks. Look for a step where the belt has been running, and confirm the sheave faces are free of oil, grease and built-up debris. Verify the sheaves open and close through their full travel and that the spring or actuator returns them correctly. Any wear that has changed the face angle will keep a new belt from seating properly.
Confirm the belt marking on the old part reads 28x950 and that the replacement matches it. Measure the center distance and check alignment between the two shafts before the belt goes on. Set the correct tension for the drive, then run it under load and recheck. If the old belt failed early, correct the sheave condition first so the same failure does not repeat.
Send the part number 28x950, the machine or drive it fits, and a photo of the belt marking and the sheaves through WhatsApp or email. Our team replies promptly and can help confirm the right belt or suggest an equivalent from what we carry.
Dimensions
- Length
- 950mm
Frequently asked questions
- How do I confirm this is the right belt for my drive?
- Read the marking on the back of the belt you are replacing. If it shows 28x950 and the drive is a variable speed application, this Gates Multi-Speed belt matches that size. Send us the marking and a photo if you want it checked before you order.
- What should I inspect before fitting a new variable speed belt?
- Check the sheave flanks for wear, grooves and steps, make sure the sheaves move through their full range, and confirm the shafts are aligned. Clean the faces and set tension to the drive specification. Correcting sheave wear first protects the new belt.
- What do you need to quote this belt?
- Send the part number 28x950, the quantity, and the machine or drive it fits, along with a photo of the belt marking if you have one. We will confirm the belt or suggest an equivalent from what we carry.