FAG AK56425-56662-XL tapered roller bearing

FAG AK56425-56662-XL belongs to tapered roller bearing, part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for AK56425-56662-XL and any equivalents.

Tapered roller bearings in the FAG AK-XL series are built for shafts that see radial and axial forces at the same time. The angled raceways and tapered rollers make line contact, which spreads the load across the assembly. Gearboxes, wheel hubs and general industrial machinery are typical homes for this line, and MR Industrial Accessories supplies it.

Reading the code helps you order the right part. The letters AK mark the tapered roller bearing assembly, the digits that follow describe size and internal design, and XL points to the current FAG generation. A code such as AK497-493-XL pairs one cone with one cup, and the same logic applies to AK33885-33822-XL and AK36690-36620-XL, where the two number groups define the mounting pair.

These bearings show up in demanding sectors: metallurgy, cement, mining and food processing among them. Speed reducers, mills, conveyor belts, pump equipment and farm machinery use them often. Transmission shafts and support rollers rely on their combined-load capability, and rail and port operations value them where rugged, dependable performance matters. MR Industrial Accessories stocks this line for both equipment builders and maintenance departments.

Selection starts with the radial and axial loads, the operating speed and the surrounding conditions. During mounting, alignment must be precise and axial clearance set correctly, typically through shims or nuts. Grease or oil both work as lubricants, with the choice driven by speed and temperature. Seals or covers keep lubricant in and contaminants out, so they deserve attention. When bearings run as a pair, keep both in the same series and apply the correct preload.

Interchange between brands is possible because tapered roller bearings follow international standards, but small differences in dimensions and tolerances mean you should confirm the code and specifications before substituting. FAG, a brand MR carries, is one option to consider. When swapping out a bearing from another maker, compare bore diameter, outer diameter and width; with those three figures, we can point you to a suitable equivalent.

Send the full code by WhatsApp to request a quote. If the code is not available, share the measurements or a photo of the part and we will help identify it. Our team responds quickly with guidance on selection and mounting.