FAG AH240/530G-H withdrawal sleeve

FAG AH240/530G-H belongs to withdrawal sleeve, part of our Bushings and sleeves range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for AH240/530G-H and any equivalents.

A withdrawal sleeve from the FAG AH series sits between a cylindrical shaft and a bearing with a tapered bore, and it is the part that carries the axial force when the bearing is pushed into place or pulled off again. Because that force travels through the sleeve instead of the raceways, mounting and dismounting stay controlled and the shaft surface is left intact. For anyone planning a scheduled shutdown, the sleeve is what makes the bearing fit repeatable.

Read the code from left to right. AH marks the withdrawal sleeve family. The number that follows points to the shaft size the sleeve is built for. The G-H ending covers design variants, which is where thread type and the dimensions of the threaded section come in. So AH39/500G-H, AH39/530G-H and AH39/560G-H are all the same series aimed at bearings with different bores. Matching a sleeve to a job means cross-referencing the shaft diameter against the bearing that will be mounted on it.

These parts turn up wherever large tapered roller bearings are fitted: gearboxes, presses, ball mills, lifting equipment, and plant in steel, cement, mining, paper, flour milling and aggregate processing. On the maintenance side, they let a bearing come off without hammer blows or heavy heating, which keeps the risk of early failure down and makes planned downtime easier to schedule.

Selection comes down to three checks: shaft diameter, the diameter of the bearing's tapered bore, and thread pitch. At mounting, grease the thread and the contact faces so the sleeve seats evenly, then apply force axially and gradually, never as an impact. Confirm shaft and bearing are aligned before you tighten, and make sure the sleeve goes on clean, with no burrs.

Other manufacturers list withdrawal sleeves under their own designations, but the job they do is the same. When you are chasing an equivalent, compare the main dimensions and the thread type rather than trusting a similar part number. MR Industrial Accessories LLC supplies the FAG brand within its fastening and retention range, and can point you to the sleeve that suits your equipment.

Send the part number, or the bearing model together with the shaft diameter, by WhatsApp or email. Our team replies promptly, suggests equivalents where they exist, and helps you confirm the right choice for the application.