DODGE TB-SCFS-107-SHFS flange bearing 2 holes

DODGE TB-SCFS-107-SHFS belongs to flange bearing 2 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for TB-SCFS-107-SHFS and any equivalents.

The DODGE ER-Series Y-bearing housing is a two-bolt flange unit that mounts directly to a structure and accepts a rotating shaft. It supports and locates shafts where a compact, self-aligning assembly is needed, and MR Industrial Accessories supplies this line and can help you match the right variant to the job.

Reading the code helps you order the right unit. TB identifies the insert bearing housing family, SCFS covers the two-bolt flange with an ER-Series insert, and the number in the middle is the nominal shaft diameter. The SHFS suffix describes how the insert is sealed and locked. That is why TB-SCFS-012-SHFS, TB-SCFS-014-SHFS and TB-SCFS-100-SHFS all exist side by side: only the shaft size changes, not the unit type. Send the full part number and we can point you to a compatible alternative.

Typical installations include belt conveyors, bucket elevators, mixers, screens, fans and packaging lines, as well as water treatment equipment and road machinery. Food plants, cement plants, paper mills, cold storage facilities and agro-industrial sites use them because the two-bolt flange makes anchoring to sheet metal or profile straightforward. The ER-Series spans shaft diameters common in these duties, so a worn unit can be replaced without reworking the housing.

Selection comes down to shaft diameter, load type and the operating environment. The insert sealing determines how much contamination the unit tolerates, so a reinforced configuration is worth considering in dusty or humid areas. Check flange alignment before tightening the bolts, and do not force the insert during mounting. In most cases the insert bearing is lubricated for life; where the equipment runs hot or continuously, inspect the sealing and the shaft locking.

Interchangeability between brands of Y-bearing housings depends on the dimensional standard and the insert locking method. The same shaft diameter can differ in flange width, hole spacing and set screw type, so size alone is not enough to confirm a match. To replace an existing unit, send the part number stamped on the housing or the flange dimensions, and we will identify the compatible option within the DODGE line or another brand we supply.

MR Industrial Accessories supplies DODGE as a brand. For a Y-bearing housing on your equipment, message us on WhatsApp or email with the TB-SCFS number from the nameplate, or with the shaft and flange dimensions. We reply promptly and, when needed, suggest the variant that fits your application.