DODGE TB-SCFS-104S-SHFS flange bearing 2 holes

DODGE TB-SCFS-104S-SHFS belongs to flange bearing 2 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for TB-SCFS-104S-SHFS and any equivalents.

This mounted assembly pairs a two-bolt flange housing with a DODGE ER-Series insert bearing. It holds rotating shafts on flat surfaces, with the flange secured by two bolts. The ER-Series is a line of mounted ball bearings common in power transmission and conveying equipment.

The part number breaks into blocks. Letters at the start show the unit type and series; the digits that follow give the shaft diameter in inches or its metric equivalent; the final suffix covers sealing, housing material or mounting arrangement. Take TB-SCFS-104S-SHFS: a two-bolt flange unit with an ER-Series insert, where 104 is the shaft diameter and SHFS is the sealing and fastening variant. Reading the code this way lets you order the full number without confusion.

Typical settings include food, textile, chemical and material handling operations, on conveyors, mixers, fans and process machines. Food and beverage plants, meatpacking and packaging lines often use the two-bolt flange because it mounts easily to sheet metal or profiles. Agricultural equipment and grain handling systems also use it where a shaft needs rigid, easily aligned support.

Selection depends on shaft diameter, load type (radial, axial or combined) and site conditions. The insert seal sets the level of protection against dust, water and cleaning agents; for damp areas or frequent washdowns, choose a reinforced seal. Insert bearing lubrication is normally permanent, though severe duty may call for relubrication. Flange-to-shaft alignment matters: a poorly mounted flange speeds up wear. Check internal clearance and how the insert locks to the shaft as well.

Interchange with other brands is possible when mounting dimensions, shaft diameter and fastening type line up. DODGE ER-Series units have counterparts elsewhere, but tolerances and seals differ. A part number match alone is not enough: confirm flange dimensions, hole spacing and center height. Our team can point you to a compatible alternative.

For this housing or another ER-Series variant, send the complete part number by WhatsApp. We will quote promptly and, for a special configuration, suggest the alternative that best fits your application.