DODGE P2B-SXRU-75M-NL pillow block bearing

DODGE P2B-SXRU-75M-NL belongs to pillow block bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P2B-SXRU-75M-NL and any equivalents.

A DODGE SXRU series Y-bearing housed unit arrives as one assembled piece: cast iron pillow block plus insert ball bearing, bolted straight onto the frame. Shaft guidance, alignment and sealing are already handled inside the unit, so installation is quicker than setting up a split housing and a separate bearing. MR Industrial Accessories supplies this line to maintenance and purchasing teams in the United States and Latin America.

Read the code in segments. Take P2B-SXRU-17M-NL: the leading letters and digit describe the housing style and how it locks; SXRU marks the insert bearing family; the middle figure is the shaft size; and the M and NL suffixes cover seal and locking variants. P2B-SXRU-30M-NL and P2B-SXRU-75M-NL work the same way at other shaft sizes. The full part number is what we need to match your unit.

Typical duty includes belt conveyors, bucket elevators, mixers, screens, fans and process lines in food, chemical and aggregate operations. Dusty or damp conditions call for a unit with solid sealing and grease points you can reach without dismantling anything. The housing takes the radial load and lets the shaft sit on sheet metal or structural profiles without machined seats.

Selection comes down to shaft diameter, the radial and axial loads involved, and the sealing the environment demands. Depending on the variant, the insert locks to the shaft through set screws or a mounting sleeve, and both housings should be checked for alignment before final tightening. Grease enters through the channel in the housing; use the lubricant rated for your operating temperature and avoid mixing different bases. Under vibration, recheck set screw tightness.

Interchange between Y-bearing housing brands is judged on shaft size, hole spacing and center height, not on the commercial code. A unit from another maker with a matching shaft may sit at a different mounting height or bolt pattern, so drawings have to be compared before confirming a swap. For a replacement, send the code stamped on the housing or the key dimensions and we will point you to the compatible option.

When a unit is down, message us on WhatsApp with the housing part number, or with the shaft size and locking type. We quote the assembly and, if you need a different variant within the series, we source it. Technical selection and mounting support are part of the service.