DODGE P2B-SXRAG-35M pillow block bearing

DODGE P2B-SXRAG-35M belongs to pillow block bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P2B-SXRAG-35M and any equivalents.

The DODGE SXR AG pillow block is a ready-to-mount unit that pairs a split cast iron housing with an insert ball bearing. It arrives pre-aligned and pre-lubricated, so it supports rotating shafts without extra setup. The design allows the insert to be swapped out without pulling the whole transmission apart, which keeps maintenance time down.

Reading the code helps you pick the right unit. The P stands for pillow block, and the number after it gives the size or the number of mounting holes. Next is the series, SXR AG, which sets the insert and seal type. The M at the end marks the metric mounting variant. So P2B-SXRAG-20M, P2B-SXRAG-30M and P2B-SXRAG-50M are the same unit in different shaft sizes.

You will find these blocks on belt and roller conveyors, bucket elevators, mixers, blowers, centrifugal pumps and packaging lines. They handle dusty, humid or washdown-heavy environments well. The cast iron housing takes radial load, and the ball insert absorbs misalignment from long shafts or welded frames.

Start your selection with shaft diameter and load type—usually pure radial, sometimes with axial in inclined equipment. Match the seal to the environment: single contact for clean interiors, labyrinth or reinforced where water, abrasive dust or chips are present. Mount on a flat, rigid base, tighten bolts in a cross pattern, and check alignment before final torque. The unit is greased at the factory; replenish according to duty cycle and temperature.

Interchangeability across Y-bearing brands comes down to mounting dimensions: hole spacing, height to shaft center and shaft diameter. Find an equivalent that matches those and the sealing type. The SXR AG series uses ER-Series inserts, so often only the bearing is replaced and the housing stays.

For a replacement or a new line, send the code on the part or your shaft dimensions via WhatsApp or email. We will quote the DODGE reference and suggest a compatible alternative if needed. Our team supports maintenance and purchasing with practical technical advice.