DODGE P2B-SCFS-010L-SHFS pillow block bearing

DODGE P2B-SCFS-010L-SHFS belongs to pillow block bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P2B-SCFS-010L-SHFS and any equivalents.

The DODGE SCFS series pillow block with insert bearing is a mounted unit that pairs a cast iron housing with an insert ball bearing. It arrives assembled and factory lubricated, so it can be bolted directly to a flat base to support and guide rotating shafts where alignment and sealing matter.

The part number tells you the configuration. Take P2B-SCFS-008L-SHFS: P2B means a two-bolt pillow block, SCFS is the housing and insert series, the middle number (008, 010) is the nominal shaft diameter, and the L and SHFS suffixes cover the seal type and insert locking method. Reading the code this way lets you pin down the exact variant for each piece of equipment.

These units are common on belt and roller conveyors, bucket elevators, mixers, screens, centrifugal pumps and process lines in food, chemical and aggregate plants. They also show up in water treatment equipment and agricultural machinery, where dust or humidity calls for a sturdy support that is straightforward to swap during a maintenance shutdown.

Selection comes down to shaft diameter, load type and rotation speed, plus the seal that matches the environment: simple contact for clean areas, more closed designs for dust or liquids. When mounting, set the pillow block on a flat, rigid surface, line up the mounting holes and tighten the bolts in pairs. The insert locks to the shaft with the set screws on the inner ring; lubricate and check clearance before startup.

Mounted pillow blocks interchange between manufacturers by shaft diameter, hole spacing, height to center and seal type, not by part number alone. So when you need an equivalent, compare those dimensions and the insert locking method. At MR Industrial Accessories we point out the compatible alternative when the original reference is not the one you are after.

To replace an SCFS series pillow block, send the full part number from the part, for example P2B-SCFS-008L-SHFS, along with the shaft diameter and a photo of the mounting. We will quote the DODGE reference or the best alternative for your equipment, and we reply promptly.