DODGE P2B-SCEZ-015-SHCR pillow block bearing

DODGE P2B-SCEZ-015-SHCR belongs to pillow block bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P2B-SCEZ-015-SHCR and any equivalents.

The DODGE SCEZ Y-bearing pillow block is a mounted unit made up of an insert ball bearing seated in a split cast iron housing. It carries rotating shafts on transmission, conveying and process equipment where the shaft needs solid support and the installation has to stay simple. MR Industrial Accessories LLC supplies this line and helps buyers match the right size to the job.

Reading the SCEZ code helps when you are comparing references. The P at the front stands for pillow block, the digits after it give the size, and the closing letters describe the insert and how it seals. A three-digit number at the end points to the shaft size, while asterisks in a listing mark variants that differ in sealing or locking.

Typical duty includes belt conveyors, bucket elevators, mills, mixers, centrifugal pumps and industrial fans. Food plants, cement operations, tanneries, meat processing and aggregate handling all rely on units like these, since dust, moisture and washdown are part of daily operation. The cast iron housing paired with a reinforced insert seal handles that environment, and maintenance stays straightforward because the bearing can be swapped out without pulling the shaft apart.

Sizing starts with the shaft diameter, then the radial and axial loads you expect, then the sealing the surroundings demand. During mounting, line the housing faces up with the base, tighten the mounting bolts evenly, and confirm the insert still turns freely. Lubrication applied at the factory normally covers the service life, though high temperature or high speed calls for periodic checks of the lubricant and internal clearance.

Mounted units like these interchange between manufacturers when shaft size, hole spacing and center height line up. For a quote, the complete code off the old pillow block is the fastest route, or send the main shaft and base dimensions instead. MR Industrial Accessories LLC can point you to a compatible option within the DODGE line or another brand the company carries, with no equipment modification needed.

Replacing a Y-bearing pillow block is easy to start: send the code or a photo of the part through WhatsApp or email. The team replies promptly, suggests equivalents and helps you confirm the selection so the new unit does the same job as the one it replaces.