DODGE P2B-SCAH-50M pillow block bearing

DODGE P2B-SCAH-50M belongs to pillow block bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P2B-SCAH-50M and any equivalents.

The DODGE SCAH series pillow block is a mounted unit that pairs a cast iron housing with an insert ball bearing. It arrives pre-aligned and pre-lubricated, so it can go straight onto the shaft. Typical duty includes conveyors, fans, mixers and other power transmission equipment that needs a rigid base with two mounting holes. MR Industrial Accessories supplies this line with technical guidance to match the unit to your shaft diameter and operating conditions.

Reading the part number helps you order the right unit. In a reference such as P2B-SCAH-17M, P2B-SCAH-20M or P2B-SCAH-35M, the P2B block tells you it is a two-hole pillow block. SCAH identifies the housing family and the insert type. The final number with the M suffix gives the shaft bore size and marks the metric mounting variant. The housing geometry stays the same across these references; only the bore changes. With the complete part number, there is no ambiguity about which unit you need.

These pillow blocks show up in food and beverage plants, aggregate processing, pulp and paper mills, and packaging lines. They also serve air conditioning equipment, conveyor belts, bucket elevators and machine tools. Maintenance teams choose them for the robust cast iron housing and because the insert can be replaced without pulling the whole shaft apart. MR Industrial Accessories supplies them for maintenance work and new projects across the United States and in several Latin American countries.

Start your selection from the shaft diameter the equipment requires, then check the radial and axial load at the mounting point. Look at how the insert is sealed: in dusty or wet areas, extra protection is worth considering. During installation, set the housing on a flat, clean surface, tighten the mounting bolts in a cross pattern, and verify alignment with a straightedge or dial indicator. The insert is greased at the factory; once in service, follow the equipment's greasing schedule and avoid over-greasing, which can damage the seals.

Mounted units like these can be swapped between manufacturers when the shaft diameter, center height, hole spacing and insert locking type all match. To request an equivalent, send the full part number and the main dimensions, and the compatible unit can be identified. Do not mix inserts from different series in the same housing, since the outer ring and locking system differ. If anything is unclear, ask us and we will point you to the alternative that fits your equipment.