DODGE P2B-GT-30M pillow block bearing

DODGE P2B-GT-30M belongs to pillow block bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P2B-GT-30M and any equivalents.

This mounted unit from DODGE pairs a cast iron housing with an insert ball bearing. It arrives aligned and pre-lubricated, ready to support a rotating shaft where space is tight and installation needs to stay simple. The self-aligning design suits conveyors, processing lines and agricultural equipment, and the whole assembly can be swapped out without machining the seat.

Reading the GT/GTM code helps you find the right unit. The letters tell you the housing style and how it mounts; GT identifies the series, and the number that follows is the shaft size in millimeters. The M suffix points to a specific sealing and lubrication configuration. With those three pieces of information, you can locate the equivalent unit in the same family.

These units show up on belt conveyors, bucket elevators, mixers, screens and milling machinery. Dusty or wet conditions call for a sealing variant with more protection, so it pays to match the insert to the environment. Correct installation means a flat base, a properly fitted insert on the shaft, and aligned housings. Re-greasing intervals depend on the duty cycle and how dirty the surroundings are.

When comparing brands, Y-bearing pillow blocks with insert bearings interchange by part number and key dimensions: shaft diameter, center height and bolt hole spacing. For a quote, send the full code and, if you have them, the seat dimensions. If the original reference is not what you need, we can point you to a compatible alternative.

To replace a unit, message the code or a photo of the nameplate. We will quote the pillow block and suggest a compatible option. We also help with sealing, lubrication and mounting questions so the unit stays aligned and performs as expected.