DODGE P2B-DLUEZ-104S-SHCR pillow block bearing

DODGE P2B-DLUEZ-104S-SHCR belongs to pillow block bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P2B-DLUEZ-104S-SHCR and any equivalents.

The DODGE DLUEZ series Y-bearing housing is a mounted pillow block unit that combines a cast iron housing with a ball bearing insert. The insert has an extended inner ring and is locked onto the shaft, while the housing can be aligned on the mounting surface. This design suits transmission shafts in equipment that needs a compact, self-aligning assembly with straightforward installation, retained lubrication, and protection from dust and moisture.

The code structure helps you identify the right unit. Take P2B-DLUEZ-104S-SHCR: P2B denotes the two-bolt split pillow block housing. DLUEZ specifies the housing family and insert type. The number 104S corresponds to the shaft diameter in inches from the series table. SHCR describes the sealing and retention arrangement. Changing the code typically means a different shaft size or seal type, while the mounting method stays the same.

These units are common in belt and roller conveyors, mixers, screens, bucket elevators, fans, and process lines across food, chemical, and aggregate operations. They also appear in material handling equipment and agricultural machinery. In dusty or wet conditions, a closed housing with extended maintenance intervals is often required.

When selecting, begin with the shaft diameter and load type. The DLUEZ series uses an insert with set screws or a collar, depending on the variant. Confirm the sealing requirement: SHCR indicates a seal for fine dust and splashes. During installation, set the housing on a flat surface and align the holes before tightening. Misalignment can reduce insert life. Use grease compatible with the operating temperature and check radial clearance before start-up.

Cross-brand replacements are matched by mounting dimensions: hole spacing, height to shaft center, shaft diameter, and fixing type. A housing from another brand with the same geometry may work, but sealing and load capacity should also be compared. If the code does not match, send the dimensions or model to MR via WhatsApp and we will identify a compatible alternative.

MR supplies DODGE bearings, housings, and power transmission components. For the DLUEZ series Y-bearing housing or a variant with a different shaft diameter, send the code or equipment dimensions through WhatsApp or email. Our team responds promptly and can suggest equivalents and help with selection.