DODGE P2B-DLUEZ-103-SHCR pillow block bearing

DODGE P2B-DLUEZ-103-SHCR belongs to pillow block bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P2B-DLUEZ-103-SHCR and any equivalents.

The DODGE DLUEZ series is a split pillow block unit that pairs an insert ball bearing with a housing bolted to the frame. It supports rotating shafts in conveyors, drives and process equipment where space is tight and mounting must be straightforward. MR Industrial Accessories supplies this line and helps you match the right variant to your application.

Part numbers in the DLUEZ family follow a structured format. P2B at the front denotes the split pillow block housing style. DLUEZ identifies the insert bearing series, including its sealing arrangement. The digits that follow give the shaft diameter in inches per the series table, and the SHCR suffix marks a particular build within the family. Quoting the complete number removes any ambiguity about the unit you need.

Typical installations include belt conveyors, bucket elevators, mixers, mills, screens and process lines in food, chemical and aggregate operations. Dust, moisture and frequent washdowns are common in these settings. Because the housing splits, the insert can be serviced or replaced without pulling the entire shaft, which matters when work is tied to scheduled shutdowns.

Selection depends on shaft diameter, load type and the operating environment. The insert seal determines protection against dust and water, so choose the appropriate variant when washdowns or fine particles are present. Insert bearings are lubricated for life at the factory, but the seal should be inspected at each maintenance interval. During mounting, check that the housing aligns with the shaft and that the base sits flat; misalignment speeds up wear on both insert and seal.

Across mounted unit families, series from different manufacturers can often be interchanged when shaft diameter, housing type and mounting dimensions agree. A similar part number is not sufficient: compare base geometry, height to center and the insert locking method. If your equipment uses a DODGE DLUEZ unit, we can point you to a compatible option or source the exact reference.

Send the part number of the unit being replaced by WhatsApp, along with a photo of the housing and the shaft measurement. With that information we will quote the matching DODGE reference or the best alternative for your equipment. We can also advise if a different housing type or seal would better handle a demanding environment.