DODGE P2B-DLMAH-215 pillow block bearing
- Brand
- DODGE
- Category
- Bearing housings
- Subcategory
- Y-bearing unit
- Series
- D-Lok
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DODGE P2B-DLMAH-215 belongs to pillow block bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P2B-DLMAH-215 and any equivalents.
The DODGE D-Lok series is a mounted pillow block assembly that pairs a split cast iron housing with an insert ball bearing. It supports rotating shafts in transmission equipment where alignment and straightforward mounting matter. What sets the series apart is its shaft fixing method, which makes adjustment and disassembly easier during maintenance work.
The code is read in blocks. The P2B prefix identifies a two-bolt pillow block, with base and housing formed as one piece. Next comes DLMAH, which points to the insert type and the D-Lok fixing system. The trailing number gives the shaft diameter in hundredths of an inch: 100 is 1 inch, 103 is 1 3/16, 107 is 1 7/16 and 200 is 2 inches. So the full reference tells you mounting style, series and size at a glance.
You will find these units on belt conveyors, bucket elevators, mixers, blowers and process lines in food, chemical and aggregate plants, as well as in sugar mills, meat plants, water treatment facilities and metalworking shops that build equipment around transmission shafts. The cast iron housing takes radial loads and some axial thrust, while the ball insert runs at moderate speeds with low maintenance.
Selection comes down to shaft diameter, load type and the environment. The insert seal determines how much contamination the unit tolerates, so dusty or humid locations call for reinforced protection. Because the D-Lok system locks the bearing to the shaft without set screws on the outer ring, the risk of loosening is reduced. At mounting, verify that the base is aligned and leave the axial clearance the shaft needs for thermal expansion.
Interchangeability among mounted bearing brands rests on standardized housing and shaft dimensions. A two-bolt pillow block with the same shaft size and hole pattern can stand in for another brand, provided the permissible loads and seal type are respected. To work out an equivalent, send the complete code along with your shaft measurements and we will point you to the compatible option.
Dimensions
- Número de producto
- 128489
- Bore
- 2-15/16 in
Frequently asked questions
- What does the last number mean in a code such as P2B-DLMAH-107?
- It expresses the shaft diameter in hundredths of an inch, so 107 equals 1 7/16 inch and 200 equals 2 inches. Send the full code or your shaft size and we will quote the D-Lok housing you need.
- How is a pillow block with insert bearing mounted?
- Set the base on the structure, line up the holes and bolt it down. The insert is then fixed to the shaft using the D-Lok system. Check alignment and leave the required axial clearance. If anything is unclear, contact us via WhatsApp.
- Can a housing from another brand be replaced with a DODGE D-Lok?
- Yes, when shaft diameter, hole pattern and permissible loads match, since interchangeability follows standardized dimensions. Send the original housing code and shaft measurements so we can identify the compatible alternative.