DODGE P2B-DLM-65M pillow block bearing

DODGE P2B-DLM-65M belongs to pillow block bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P2B-DLM-65M and any equivalents.

For shafts that need dependable radial support in general machinery, the DODGE DLM series Y-bearing pillow block combines an insert bearing with a split housing and D-Lok locking. The locking system holds the insert firmly on the shaft, and the split housing design simplifies mounting and service. Conveyors, fans, mixers, and similar power transmission equipment are common applications. MR Industrial Accessories supplies this line.

Reading the code helps you order the right unit. The letter P at the start means pillow block. The digit after it shows how many mounting holes the housing has, for example 2. The letter B identifies the split housing type. The DLM suffix marks the series with D-Lok locking, and the number at the end — 30M, 35M, 45M, 50M, 55M, 60M, or 65M — gives the shaft diameter in millimeters. A code such as P2B-DLM-30M therefore describes a two-bolt pillow block built for a 30 mm shaft with D-Lok locking.

These units suit plants where dust, moisture, or washdowns are part of daily operation, including food, cement, mining, and process environments. Typical equipment includes belt conveyors, bucket elevators, mixers, centrifugal fans, and packaging lines. Because the housing bolts to a flat surface and tolerates slight misalignment, installation is straightforward and maintenance time is reduced.

Selection comes down to three inputs: shaft diameter, radial load, and the conditions where the unit runs. The DLM series handles moderate loads, and the D-Lok locking screws secure the insert without set screws. Align the shaft and the base before tightening the fasteners. Correct lubrication and the peripheral seal help extend service life, and a reinforced sealing option is available in the line when dirt is a concern.

DLM pillow blocks can replace other brands of Y-bearing pillow blocks with insert bearing when the shaft diameter and hole configuration match. Have the full code ready — for instance P2B-DLM-45M — along with your working conditions. MR Industrial Accessories can point you to a compatible alternative or discuss special manufacturing if needed. The critical dimensions to compare are shaft diameter, distance between holes, and height to center.