DODGE P2B-DLH-110L-E pillow block bearing

DODGE P2B-DLH-110L-E belongs to pillow block bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P2B-DLH-110L-E and any equivalents.

A DODGE D-Lok pillow block is a mounted unit made up of two components: a flat-base cast iron housing and a ball insert bearing that locks with the D-Lok eccentric system. It holds rotating shafts in place on equipment that needs a rigid, well-aligned and simple mounting, including conveyors, mills, mixers and industrial fans. MR Industrial Accessories LLC supplies this line for power transmission applications across the United States, Canada, Mexico and South America.

Reading the code helps you order the right unit. Take P2B-DLH-110L-E: P stands for pillow block, 2 marks the two-bolt housing series, and B tells you the mounting uses a ball insert bearing. DLH points to the D-Lok family with eccentric locking. The 110 is the shaft diameter in inches per the series table, while L identifies the housing variant and E the sealing. With all of that, the complete assembly can be specified.

Typical users are food and beverage plants, cement works, mining and aggregate operations, and material handling facilities, where these units sit on belt conveyors, bucket elevators, screens, horizontal mixers and blowers. The cast iron housing takes radial loads plus a degree of axial thrust, and the ball insert runs at moderate speeds with limited maintenance attention. Its flat base and mounting holes make anchoring to steelwork or concrete straightforward.

Selection comes down to shaft diameter, expected radial and axial load, and site conditions. The E sealing keeps out dust and moisture, but where washdown is frequent or particles are fine, it pays to review which seal type suits the job. D-Lok eccentric locking makes fitting onto ground shafts of standard tolerance simple. Before tightening, confirm the base is aligned and that pillow blocks sit parallel to one another. Grease applied at the factory can be topped up with a compatible product chosen for your temperature and speed.

When comparing mounted units between brands, shaft diameter, housing configuration and locking method are the variables that matter. A matching diameter alone is not enough; center height, hole spacing and insert type also need checking. Use those same points to find a compatible option, and our team will point you to the one that fits your equipment.

To get a quote, send the full part number from the nameplate or drawing, for example P2B-DLH-110L-E, by WhatsApp or email, along with the shaft diameter and a photo of the mounting if available. We reply promptly and can suggest equivalents or help you choose. MR Industrial Accessories LLC also manufactures split pillow block housings, roller chains and sheaves to complete an order.