DODGE P2B-DLEZ-104S-SHCR pillow block bearing

DODGE P2B-DLEZ-104S-SHCR belongs to pillow block bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P2B-DLEZ-104S-SHCR and any equivalents.

A DODGE DLEZ pillow block is a mounted bearing unit that arrives preassembled and aligned from the factory, pairing a cast iron housing with an insert ball bearing. It is designed to support rotating shafts where a sturdy unit, straightforward installation and self-aligning capability are needed. MR Industrial Accessories supplies this line and can help you identify the correct variant for your shaft.

To read a DLEZ part number, break it into sections. Take P2B-DLEZ-104S-SHCR: the initial letters and digit describe the housing style and how it mounts; DLEZ denotes the insert and housing family; the following number, 104, is the nominal shaft diameter in inches; and the trailing suffixes, S and SHCR, cover construction details such as seal type, shaft locking method and housing features. The full code removes any ambiguity about the unit you need.

These units are common in belt and roller conveyors, packaging lines, mixers, blowers, exhausters, milling lines and process equipment across food, chemical and materials plants. In humid or dusty settings, a closed housing and a well-sealed insert are especially important.

Selection starts with shaft diameter and load type: mostly radial in conveyors, with some axial depending on the application. Consider the sealing, because water or fine dust may call for an insert with a reinforced seal. When mounting, place the housing on a flat, rigid base, tighten the bolts without distorting the housing, and verify shaft alignment before final securing. The insert is grease-lubricated, and the relubrication interval depends on speed and operating temperature.

Mounted units of this type can be interchanged between manufacturers if the shaft diameter, center height, hole spacing and locking type match. Often the entire unit is replaced with another brand offering the same configuration, or just the insert is changed when the housing remains in good condition. Compare the main dimensions and the insert locking system on the shaft, not only the commercial part number.

If you have the part number of the unit being replaced, send it via WhatsApp to MR Industrial Accessories along with the shaft diameter and a photo of the mounting. We will quote the equivalent DODGE reference and, if needed, point you to a compatible alternative from another brand with the same mounting dimensions.