DODGE LFT-SC-30M-NL flange bearing 2 holes

DODGE LFT-SC-30M-NL belongs to flange bearing 2 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for LFT-SC-30M-NL and any equivalents.

The DODGE SC series 2-bolt flange Y-bearing unit is a mounted assembly that pairs a cast iron housing with an insert ball bearing. It arrives pre-aligned and pre-lubricated from the factory. The unit bolts to a flat surface and supports a shaft in applications that call for a rigid, low-profile mount, with the shaft passing through or ending at the unit.

Reading the part number helps you order the right replacement. The letters LFT denote the 2-bolt flange housing, SC identifies the insert series, the digits after the hyphen give the nominal shaft diameter, and the trailing letters show sealing or configuration options. The suffix M marks the insert version and NL the closure type; keep both when specifying a replacement. All numbers in the series use the same housing and differ only in shaft diameter.

These units are common on belt and roller conveyors, mixers, screens, bucket elevators, packaging lines, water treatment equipment, centrifugal fans, pumps and agricultural machinery. The 2-bolt flange mounts directly to folded sheet metal or profile structures without machining. As self-aligning units, they absorb small shaft-to-base misalignments.

Selection starts with shaft diameter and load type. The SC series is the medium-section option within the insert bearing line. Match the sealing to the environment: dusty, wet or frequently washed areas call for a more sealed closure than the standard one. During mounting, place the flange on a clean, flat surface, tighten the screws in a cross pattern, and confirm the shaft turns freely. Lubricate according to the duty cycle and verify alignment before start-up.

Flange insert housing dimensions are consistent across manufacturers, but part numbers are not directly interchangeable: sealing, shaft locking method and housing height vary. When replacing a unit, compare shaft diameter, hole spacing and closure type rather than the number alone. We can identify the compatible alternative for those same dimensions.

If you have the housing part number, send it by WhatsApp along with the shaft diameter and a photo of the mounting. We will quote the unit and, if needed, the associated inserts and accessories. We supply the DODGE line and equivalent alternatives to help keep your machine in production.