DODGE LFT-SC-104S-NL flange bearing 2 holes

DODGE LFT-SC-104S-NL belongs to flange bearing 2 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for LFT-SC-104S-NL and any equivalents.

A DODGE LFT-SC unit combines a two-bolt flange housing with a ball insert bearing, holding a shaft at a right angle to a flat mounting face. Maintenance teams choose this arrangement when they need a compact, self-aligning assembly that can be swapped out without major rework. MR Industrial Accessories LLC supplies the line and helps buyers match the right configuration to the shaft and the operating environment.

Reading the code helps when you order. LFT stands for the two-bolt flange housing style; SC points to the ball insert series; the figure that follows, as in LFT-SC-104S-NL, gives the insert size. The letter S marks the sealing variant, while NL tells you the unit ships without pre-lubrication, leaving the grease choice to the installer. These suffixes matter when you are matching a replacement or an equivalent.

You will find these units on conveyors, belts, agitators, fans, pumps, mills and process equipment in food, chemical, cement and aggregate operations. They suit packaging lines, balanced feed plants and material handling systems where a sturdy flange mount is needed and the bearing must absorb slight misalignment. The DODGE SC series is a familiar reference in industrial maintenance because it fits standard shafts and is widely recognized.

Selection starts with shaft diameter, then load type — radial, axial or combined — and finally the environment: humidity, dust, washdowns or elevated temperatures. The S seal guards against contaminants and lubricant loss; for intensive washdowns, consider additional seals or covers. At mounting, check that the support surface is flat and clean, line up the holes and tighten the screws evenly. Apply the grease specified for the speed and temperature, and avoid overfilling the cavity.

When sourcing a replacement, interchangeability depends on flange dimensions, shaft diameter and insert type, not just the part number. A unit from another brand can work if hole spacing, mounting diameter and center height match. MR can point you to a compatible alternative or, for special requirements, note that we manufacture split plummer block housings in-house. Always confirm equivalence against the actual equipment measurements before installing.

To request a quote for an LFT-SC housing or another SC series variant, send the full part number by WhatsApp or email. Include the model, brand and a photo of the mounting, and we will respond promptly with the option that fits your application. We can also advise on insert bearings, seals and complementary lubricants so the replacement is handled in one inquiry.