DODGE LFT-DL-015 flange bearing 2 holes
- Brand
- DODGE
- Category
- Bearing housings
- Subcategory
- Y-bearing unit
- Series
- D-Lok
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DODGE LFT-DL-015 belongs to flange bearing 2 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for LFT-DL-015 and any equivalents.
The DODGE D-Lok LFT-DL is a two-bolt flange housing built to carry a ball insert bearing. It bolts flat to a machine frame so the shaft runs at a right angle to the mounting face, which suits equipment where space is tight and the fixing has to stay rigid. MR Industrial Accessories supplies this line in a range of shaft sizes.
Read the code in three blocks. LFT tells you it is a two-bolt flange housing, DL places it in the D-Lok series, and the trailing digits give the shaft size. That is how LFT-DL-012, LFT-DL-014 and LFT-DL-100 sit in the same family: same flange body, different bore. Locking is done with an eccentric collar, so the insert grips the shaft without needing special tooling at installation or removal.
Typical duty includes belt conveyors, bucket elevators, mixers, screens and process lines in food, chemical and aggregate operations. Because the shaft exits perpendicular to the mounting face, these units work well on folded sheet metal and profile frames. Two bolts hold the flange down, which keeps the footprint small.
Start selection with the shaft diameter, then work out whether the load is radial, axial or a mix of both. Confirm there is enough room around the flange for the bolts and that the mounting surface is flat and rigid. The insert arrives pre-lubricated and sealed against dust and moisture; in harsh environments, review the sealing arrangement and how often you relubricate. Matching the alignment of paired housings keeps stress off the insert.
Flange housings from other makers use their own codes, and they do not swap one for one. Compare bore, hole spacing, flange height and the way the insert locks to the shaft before substituting. On a replacement job, send the code stamped on the old part and our team will identify the matching reference.
Dimensions
- Número de producto
- 062525
- Bore
- 15/16 in
Frequently asked questions
- How do I work out the shaft size for an LFT-DL housing?
- The last digits of the reference point to the bore, so LFT-DL-012 and LFT-DL-100 take different shaft diameters. If the code is worn or painted over, measure the shaft with a caliper and send us the reading on WhatsApp.
- What sets the D-Lok series apart from other flange housings?
- The insert is secured to the shaft with an eccentric collar, which makes fitting and removal quicker. Other designs rely on set screws or taper bushings. Which one suits you depends on how much access you have and how often the unit is serviced.
- Can a housing from another brand be replaced with a DODGE D-Lok unit?
- It can, provided the shaft diameter, the hole spacing on the flange and the mounting height all line up. Send the code of the original part by WhatsApp and we will point you to the equivalent DODGE reference.