DODGE LF-SXV-101 flange bearing 3 holes

DODGE LF-SXV-101 belongs to flange bearing 3 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for LF-SXV-101 and any equivalents.

The DODGE SXV series combines a cast iron flange housing with a ball insert bearing, delivered as one aligned unit that bolts straight onto the machine. Three bolt holes hold the flange to sheet metal or structural steel, so no machining is needed at the mounting point and the shaft stays centered with minimal fastening. The insert arrives factory-lubricated and protected inside the housing.

Reading an SXV part number is straightforward. The letters mark the flange housing family that takes an insert bearing, while the closing digits set both the shaft size and the housing variant. That is how LF-SXV-008, LF-SXV-010, LF-SXV-012, LF-SXV-014 and LF-SXV-015 line up with successive shaft diameters. The references LF-SXV-100, LF-SXV-101 and LF-SXV-102 cover those same sizes but with a different housing end. Give us the complete number and we will point you to the right variant.

Typical installations include belt conveyors, bucket elevators, mixers, screens and continuous process lines, as well as fans, pumps and water treatment equipment. The 3-bolt flange suits plants handling food, chemicals and aggregates because it mounts directly onto existing structure, and the insert bearing keeps changeouts simple while tolerating slight misalignment.

Selection starts with shaft diameter and load type, whether mostly radial or with moderate thrust. Align the flange before you tighten the bolts; the insert runs with limited internal clearance, and a flange that sits twisted will cut bearing life. Sealing options should match the environment, and a reinforced protection variant makes sense where coarse dust or frequent washdown is present. Grease comes from the factory, so in service add a compatible grease and avoid mixing different bases.

When comparing flange housings with insert bearings across brands, the deciding figures are shaft diameter, hole spacing, bolt diameter and center height. Match those and the swap is direct; if they differ, the structure needs modification or a different housing variant is required. A similar-looking part number is not enough on its own. Send the dimensions of the housing you are replacing, or the full LF-SXV reference, and we will identify the compatible option in the DODGE line.