DODGE INS-SXRH-50M insert bearing

DODGE INS-SXRH-50M belongs to insert bearing, part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for INS-SXRH-50M and any equivalents.

The Dodge SXRH insert bearing is a ball bearing with an extended inner ring, made to sit in split plummer block housings and wall units. It is the practical choice when you need to swap out the insert without replacing the housing, or when building equipment that uses a split housing. MR Industrial Accessories LLC supplies this line and helps you match the right part number to your application.

The part number tells you what you are holding. Take INS-SXRH-30M or INS-SXRH-45M: the SXRH block identifies the Dodge insert family for split plummer block housings. The digits that follow give the shaft diameter in millimeters. The trailing M points to a specific sealing and locking version. So when you read the code, the number right after SXRH is your shaft size. Send that full reference on WhatsApp or by email and we will quote the exact item.

You will find these inserts on belt conveyors, bucket elevators, mixers, mills, and process equipment in food, chemical, and aggregate plants. They also show up in agricultural machinery and packaging lines. In plants where dust and humidity are hard on mountings, an insert that seals well and replaces easily is a common maintenance answer. MR Industrial Accessories LLC supports operations across the United States and in several Latin American countries with this line.

Selection comes down to two things: the shaft diameter and the housing where the insert sits. Sealing matters most in dusty or wet areas, where a reinforced seal version is the better call. During mounting, clean the seat, make sure the shaft is free of burrs, and tighten the locking set screws with the correct wrench. Factory lubrication normally covers the service life, but in severe conditions you can relubricate if the insert has a lubrication passage. Keeping housings aligned avoids lateral loads.

On equivalents, Dodge SXRH inserts can be interchanged with other brands that use the same millimeter diameter naming and a similar outer ring layout. No universal table exists, because interchangeability depends on housing dimensions and the locking system. Send us the original part number or the shaft and housing dimensions, and we will point you to a compatible option from what we supply.

To replace a Dodge SXRH insert, just send the full part number on WhatsApp or email: INS-SXRH-30M, INS-SXRH-55M, or whichever applies to your equipment. We will quote it promptly. If you need a variant that is not listed, write to us with the model or dimensions and we will guide you to the right choice.