DODGE INS-SCM-111-CR insert bearing

DODGE INS-SCM-111-CR belongs to insert bearing, part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for INS-SCM-111-CR and any equivalents.

The DODGE SC series insert is a ball bearing built with an extended inner ring, made to sit in split plummer block housings as well as wall and pillow block units. It suits setups where alignment, mounting and removal should be possible without pulling the whole shaft apart. MR Industrial Accessories supplies this line and helps you match the right size to your equipment.

Reading the code helps you order the right insert. The designation starts with the INS prefix, followed by the SC series code, then the number that sets the size, and closes with the CR suffix that marks the sealing variant. INS-SCM-111-CR is one example: SCM identifies the SC insert family, while the central number fixes both the shaft diameter and the outer ring dimensions. For a quote, send the complete part number exactly as it appears on the housing or the machine plate.

Typical applications include belt conveyors, bucket elevators, mixers, screens, packaging lines and general plant equipment. They also show up on irrigation systems, mills and agricultural machinery with long shafts where fast mounting matters. Dusty, damp and moderately loaded service is where these inserts earn their place, so food, cement, mining, chemical and aggregate processing plants use them often.

Selection comes down to three things: shaft diameter, the housing type the insert will seat in, and the sealing the environment demands. A dry plant and a wash bay with pressurized water call for different sealing approaches. Before mounting, check internal clearance and lubrication, press the insert in without hammering the outer ring, and confirm the housing is aligned. Even a light load will shorten bearing life when the unit is out of line.

SC series inserts interchange between brands by shaft size and housing dimensions rather than by commercial part number. Before replacing, compare the diameter, the inner ring width, where the set screw holes sit, and the sealing type. If your housing comes from another brand, send a photo along with the shaft dimensions and we will point you to a compatible alternative.

To replace an SC insert, message us on WhatsApp with the part number or model shown on the equipment. Our team will quote the reference and, where it applies, suggest an alternative that fits your housing. We serve plants and workshops across the United States and in several Latin American countries with technical support.