DODGE INS-SCM-107-HT insert bearing

DODGE INS-SCM-107-HT belongs to insert bearing, part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for INS-SCM-107-HT and any equivalents.

The DODGE SC series insert bearing is a ball bearing with an extended inner ring, made to seat in split plummer block housings and in wall or floor units. It supports a rotating shaft in a fixed assembly that can be aligned and adjusted on site, which suits equipment running at normal plant speeds with moderate loads.

Reading the code helps you select the right insert. The letters indicate the insert family, and the number that follows gives the bore size, meaning the shaft diameter it fits. In the SCM series, the M marks the mounting variant, while the HT suffix points to a version with special heat treatment of the ring. For this reason, INS-SCM-100-HT, INS-SCM-103-HT, INS-SCM-107-HT and INS-SCM-200-HT are not interchangeable: each one matches a different shaft diameter.

Typical applications include belt conveyors, bucket elevators, mixers, screens, fans and process lines in food, chemical and aggregate plants. They also appear in agricultural machinery and water treatment equipment where the environment does not call for extreme protection. The split housing design makes replacement easier because the shaft does not have to be dismantled completely.

To choose correctly, begin with the shaft diameter and the housing type where the insert will sit. Review the sealing: a simple contact lip seal works in clean areas, while dusty or moist conditions call for more closed protection. Check internal clearance and the intended lubrication, and confirm housing alignment before tightening, since a misaligned mounting shortens bearing life. The HT suffix is intended for more demanding working conditions.

DODGE is a brand that MR supplies, and its SC series inserts have dimensional equivalents in other insert bearing lines. Interchangeability depends on shaft diameter, inner ring width and locking system, not on the code alone. If your equipment uses another brand, send the original code and shaft dimensions, and we will identify the compatible alternative and quote it.

To replace an SC or SCM series insert, contact us on WhatsApp with the code from the housing or with the shaft diameter. Our team replies promptly and, if you need a variant not listed, we will source it or quote it to your requirements.