DODGE INS-SC-104S insert bearing

DODGE INS-SC-104S belongs to insert bearing, part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for INS-SC-104S and any equivalents.

The DODGE SC series insert bearing is a ball bearing with an extended inner ring and set screw locking, intended for installation in split plummer block housings and wall units. It is used where the bearing must be fastened to the shaft and supported in a split housing, which simplifies mounting and maintenance. MR Industrial Accessories supplies this line.

The part number INS-SC-104S is decoded as follows: INS denotes an insert bearing, SC indicates the series with extended inner ring and set screw locking, 104 corresponds to the nominal bore size per the series table, and the S suffix identifies the sealing variant. To order a replacement, always provide the complete part number as shown on the nameplate or the old bearing.

These inserts are mounted in split plummer block housings, wall, flange and take-up units, and are found in belt conveyors, bucket elevators, mixers, mills, centrifugal pumps and process equipment. They are common in food plants, cement plants, tanneries, aggregate processing plants and packaging lines, where maintenance access is limited and replacing the insert without disassembling the entire housing is preferred.

When selecting the insert, confirm the shaft diameter and locking type: SC inserts use set screws on the extended inner ring. Check the sealing condition, because in dusty, wet or washdown environments a variant with an additional seal is better. During mounting, clean the shaft, ensure there are no burrs or wear, and tighten the set screws with a torque wrench to the recommended torque. Factory lubrication typically lasts for the service life, but in continuous operation relubrication according to the duty cycle is advisable.

SC series insert bearings interchange between brands by bore number and locking configuration, not by the manufacturer's part number. If the housing is from another brand, the critical factors are shaft diameter, inner ring width and set screw position. MR Industrial Accessories will identify the compatible alternative based on the part number you provide. If the insert is part of a complete unit, also identify the housing to request a quote for the assembly.

To request a quote for the DODGE SC series insert bearing, send the part number INS-SC-104S or the shaft size and housing type via WhatsApp or email. Our team responds promptly and can suggest equivalents or help you choose the right option for your equipment.