DODGE INS-GT-104S insert bearing

DODGE INS-GT-104S belongs to insert bearing, part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for INS-GT-104S and any equivalents.

The DODGE ER-Series insert bearing is a ball bearing with an extended inner ring, built to sit in split plummer block housings and mounted bearing units. It supports rotating shafts where a compact, self-aligning and straightforward mounting arrangement is needed. MR Industrial Accessories LLC supplies this line to plants, workshops and maintenance teams across the United States and in several Latin American countries.

The code tells you what you are holding. INS-GT-104S breaks down as follows: INS means insert assembly, GT covers the mounting configuration, and the S at the end marks the sealing variant. The middle figure, 104, points to the bore size in the series table. For a correct replacement, pass along the full number stamped on the housing or on the insert you are removing.

You will find these inserts in conveyors, elevators, mixers, fans, pumps and agricultural equipment. Food processing, cement, cold storage and metalworking operations rely on them where dust, moisture and moderate loads are part of daily operation. Shaft sizes across the ER-Series match those common in power transmission and material handling.

Selection comes down to three checks: shaft diameter, how the insert locks onto the shaft, and the sealing you need. During mounting, work with a clean shaft free of burrs, tighten the set screws with the right wrench and follow the recommended torque. The factory grease fill covers most installations; in wet or dusty areas, inspect the seal and relubricate on your maintenance schedule.

DODGE inserts interchange with other brands of mounted units that share the same insert geometry and shaft diameter. To get a quote, send the complete insert part number, or the shaft and housing dimensions. MR Industrial Accessories LLC will point you to a compatible alternative or to in-house manufacturing if the housing is special.

For a DODGE ER-Series insert replacement, message us on WhatsApp with part number INS-GT-104S or with your shaft and housing dimensions. We will quote promptly and help you get the mounting aligned and the sealing right for your application.