DODGE FC-SXV-200L piloted flange bearing
- Brand
- DODGE
- Category
- Bearing housings
- Subcategory
- Y-bearing unit
- Series
- SXV
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DODGE FC-SXV-200L belongs to piloted flange bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for FC-SXV-200L and any equivalents.
The DODGE FC-SXV is a piloted flange housing that carries an insert bearing, built for shafts that need support and alignment on a single mounting face. The pilot centers the assembly in the housing, and the bolt holes secure it to the structure. It suits equipment where the shaft runs perpendicular to the mounting surface, with lubrication and sealing arranged for dusty or damp conditions.
Read the code in two blocks. FC tells you it is a piloted flange configuration; SXV identifies the insert bearing series. The number that follows, as in FC-SXV-200L, gives the shaft size, and the L suffix points to the sealing or locking variant of the insert. For a replacement, copy the complete code from the nameplate or the old housing.
You will find these units on belt conveyors, mixers, bucket elevators, fans and process lines in food, chemical and aggregate plants, including equipment that runs with dust, frequent washdown or moderate vibration and needs a solid support that bolts simply to sheet metal or a welded frame.
Selection comes down to three points: shaft diameter, insert locking type (set screw or eccentric) and sealing. Contact lip seal versions handle fine dirt better; single lip versions are enough in dry areas. During installation, seat the flange flat, tighten bolts in a cross pattern and confirm the shaft turns freely. Use lithium grease per the duty cycle and check alignment with a straightedge or dial indicator.
Piloted flange housings with insert are made by several brands in standardized dimensions, but sealing, locking system and load capacity differ. Do not swap in another code just because the diameter matches: compare flange height, pilot diameter and hole spacing. If anything is unclear, send the measurements or the equipment code and we will point you to the compatible option.
MR Industrial Accessories LLC supplies the DODGE line and will quote the FC-SXV housing you need. Send the complete code, or the shaft and flange measurements, by WhatsApp or email, and the team will reply promptly with the right reference and can suggest equivalents.
Dimensions
Dimensions and tolerances: Message us the part number on WhatsApp and we'll verify its dimensions and version with the manufacturer's datasheet.
Frequently asked questions
- How do I identify the FC-SXV housing I need?
- Check the code on the housing or the equipment nameplate. The number after SXV is the shaft diameter, and the L suffix defines the sealing variant. If the code is unreadable, measure the shaft diameter and the distance between the flange holes.
- Can it be replaced by another brand?
- Yes, equivalent housings exist from other brands, but verify the pilot diameter, flange height and hole spacing. Sealing and insert locking also vary. Send us the measurements and we will indicate the compatible alternative.
- What lubrication does the insert bearing require?
- General purpose lithium grease for bearings. Frequency depends on speed and environment; in dusty or humid areas, shorten the intervals. The insert has a grease fitting, so apply until old grease exits through the seal.