DODGE FBSO-SCFS-010L-SHFS flange bearing 4 holes

DODGE FBSO-SCFS-010L-SHFS belongs to flange bearing 4 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for FBSO-SCFS-010L-SHFS and any equivalents.

The DODGE SCFS series 4-bolt flange bracket with insert bearing is a square, flange-mounted unit. Four bolts secure it to the frame, and the shaft passes through the middle. It supports transmission shafts where a rigid, centered fixing point is needed, and it can be lined up with the shaft axis before the bolts are final-tightened.

Reading the SCFS code: the letters describe the bracket type and flange layout; the following three digits give the nominal shaft diameter in inches, expressed in thousandths. The trailing L denotes the insert locking variant, while the SHFS suffix covers sealing and housing details. Within the series, the flange geometry stays the same and only the shaft size changes.

Typical duties include belt and roller conveyors, mixers, screens, fans, centrifugal pumps and packaging lines, as well as milling equipment, aggregate processing plants and material handling systems. These are positions with moderate radial load where the flange can be fixed to sheet metal or profile structures. As a mounted bearing, it removes the need to machine a housing: a flat surface with four holes is enough.

Selection starts with shaft diameter and load type. A 4-bolt flange gives a more stable fixing than a pillow block when vibration or forces from several directions are present. Match the insert sealing to the environment; dust, water or frequent washdown call for tighter protection. At assembly, set the flange on a clean, flat surface, insert the bolts without tightening, bring the shaft into line with the transmission, then tighten in a cross pattern. Lubricate the insert to suit the duty cycle and verify radial clearance before start-up.

Flange mounted bearings come from several brands under their own nomenclatures, and shaft sizes and mounting holes often correspond between equivalent lines. Interchangeability is not decided by diameter alone: check hole spacing, flange diameter, shaft center height and insert locking type. A reference with equivalent performance can be used if those dimensions are maintained. MR Industrial Accessories supplies DODGE and can point out a compatible alternative.

For an SCFS bracket on a specific machine, send the full code, the shaft diameter or a photo of the equipment nameplate via WhatsApp. With that information the reference can be quoted and, where applicable, a compatible alternative identified. The MR Industrial Accessories team replies promptly.