DODGE FB-DLEZ-104S-PCR flange bearing 4 holes

DODGE FB-DLEZ-104S-PCR belongs to flange bearing 4 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for FB-DLEZ-104S-PCR and any equivalents.

A four-bolt flange bracket paired with a DODGE ER-Series insert bearing forms a mounted unit that bolts to a flat surface. The cast housing holds the insert, which supports and guides the shaft. Because the insert is separate, it can be swapped out while the housing stays in place. This makes the assembly a practical choice for equipment that needs rigid, centered shaft support.

Reading the code FB-DLEZ-104S-PCR helps you order the right unit. FB stands for the four-bolt flange housing. DLEZ describes the insert and how it locks to the shaft. The 104S block gives the nominal shaft diameter in inches under the ER-Series. PCR covers the seal arrangement and the housing version. In this series, a higher number after the letters means a larger shaft. Use the equipment nameplate or measure the shaft to confirm the part number.

You will find these brackets on belt conveyors, bucket elevators, mixers, mills and other process equipment in food, chemical and aggregate plants. They suit mounting on sheet metal or structural profiles, and they are often used where long shafts need several aligned support points.

Selection depends on shaft diameter, the type of load (radial, axial or combined) and the conditions around the unit. The insert seal tells you whether the bracket can handle dust, water or frequent washdowns. When installing, set the flange on a clean, flat surface and tighten the four bolts in a cross pattern so the housing does not distort. Lubricate the insert through its channel, and check clearance and alignment before startup.

ER-Series brackets from different makers interchange by shaft number and flange layout, but hole spacing and center height can differ. Before replacing a unit, compare shaft diameter, hole count and spacing, and the insert locking method. If the original part number does not match, MR can suggest a compatible alternative.

Send the part number FB-DLEZ-104S-PCR or your shaft dimension by WhatsApp or email, and the team will quote it promptly. They can also help you choose the insert and housing that fit your application.