DODGE F4B-SCMED-203 flange bearing 4 holes

DODGE F4B-SCMED-203 belongs to flange bearing 4 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for F4B-SCMED-203 and any equivalents.

The DODGE SCED series 4-bolt flange bearing is a ready-to-mount assembly: a cast housing plus an insert ball bearing, bolted to a flat surface to carry a rotating shaft. You will find it on belt conveyors, mixers and fans, where the shaft needs a firm, centered support. MR Industrial Accessories supplies this DODGE line across the United States, Canada, Mexico and South America, and quotes it by part number through WhatsApp or email.

Read the code in blocks. F tells you it is a flange unit and B refers to the mounting style; the digit after that, 4, is the number of bolt holes. SCMED names the insert and housing family, and the last digits set the bore size. That is why several part numbers sit side by side in the same family: each closing number is a different shaft diameter.

Typical duty covers belt conveyors, bucket elevators, mills, screens and other process equipment, plus food plants, cement works, tanneries and metalworking shops. The four bolts hold alignment on sheet metal or structural steel, and because the unit arrives sealed and pre-lubricated, upkeep stays simple where dust, moisture or washdowns are part of the day.

Selection comes down to three things: shaft diameter, the load the shaft carries (radial, axial or both) and the surrounding conditions. The insert seal sets how much contamination the unit tolerates, so water or airborne particles call for tighter protection. When fitting, set the flange on a clean, flat face, tighten the four bolts in a cross pattern, then confirm the shaft turns freely. The grease from the factory covers start-up; after that, work to the greasing schedule of the machine.

Flange units with insert bearings swap between brands on dimensions: square flange, hole spacing and shaft diameter. Plenty of manufacturers build to those same figures, while differing in how the insert locks or how it seals. Comparing dimensions and service conditions is the practical route, and our team can point you to a compatible option from what we supply.

If you have the part number of the bearing in service, such as F4B-SCMED-107 or F4B-SCMED-115, send it over WhatsApp with a photo of the mounting and the shaft dimensions. We will quote the DODGE reference or the equivalent that suits your equipment. We also cover split plummer block housings, 2-bolt and 4-bolt flanges and insert bearings.