DODGE F4B-PSEZ-25M-P flange bearing 4 holes

DODGE F4B-PSEZ-25M-P belongs to flange bearing 4 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for F4B-PSEZ-25M-P and any equivalents.

The DODGE PSEZ line covers four-bolt flanged Y-bearing units that pair a cast iron housing with an insert ball bearing. They carry rotating shafts on flat mounting surfaces where the flange has to sit firm and alignment has to stay simple. MR Industrial Accessories supplies this line in a range of shaft sizes.

Reading the code helps you order the right unit. The opening characters describe the housing and how many holes it has, and F4B tells you the flange takes four bolts. PSEZ then points to the insert series and how it is sealed. The digits after that give the shaft size. A trailing M signals metric dimensions, and a final P identifies a housing variant.

Typical installations include belt conveyors, screening equipment, bucket elevators, mixers and packaging lines. The same units turn up in food, chemical, cement and aggregate processing, where dust or moderate humidity is present. A flat flange with four bolts and a shaft running perpendicular to the mounting face are the two conditions that have to be met on site.

Start your selection with the shaft diameter and the load pattern. PSEZ units are built for applications where radial load dominates and some axial load appears. Look at the sealing as well: an insert with a lip seal and a metal deflector holds up better around fine dust or splashes. When you mount the unit, set the flange on a clean, flat surface, tighten the bolts in a cross pattern, and confirm the shaft turns freely by hand. Grease the insert to suit the duty cycle and verify axial clearance before startup.

Interchange between brands of flanged Y-bearing units with insert bearings comes down to center height, shaft diameter, hole spacing and how the insert locks onto the shaft. Two units can share the same flange dimensions and still not be interchangeable if the locking method differs, so a drawing-to-drawing comparison is the reliable route. For a replacement on existing equipment, send the original part number and we will point you to a compatible option.

MR Industrial Accessories supplies the DODGE line. Send the part number of the unit you need by WhatsApp or email and our team will reply promptly with a quote. We can also help you pick the sealing variant or insert type that fits your application.