DODGE F4B-DLM-35M flange bearing 4 holes

DODGE F4B-DLM-35M belongs to flange bearing 4 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for F4B-DLM-35M and any equivalents.

A four-bolt flange housing paired with a DODGE D-Lok insert bearing forms a mounted unit: a cast iron body plus a ball bearing insert, bolted to a flat surface through four holes. It holds rotating shafts where the support must stay rigid and lining up the shaft is straightforward, as in belt conveyors, mixers, fans and process equipment. MR Industrial Accessories supplies this line.

Reading the code is a matter of splitting it into parts. The first letters tell you which housing style it is and how many mounting holes it has; the block in the middle points to the insert bearing series; the trailing number gives the shaft diameter in millimeters. The codes in this series are therefore four-bolt flange housings built for various shaft diameters, and the M at the end means the dimensions are metric. Once you know the pattern, you can order the exact reference.

On US plant floors these housings turn up on belt conveyors, bucket elevators, mills, balanced feed mixers, water treatment plants and refrigeration equipment. Because the flange carries four bolts, the unit can be fixed to sheet metal or structural profiles, and the shaft position can still be shifted slightly before the bolts are finally tightened. That makes it a practical choice when a solid support is needed but the part has to come off quickly during a maintenance shutdown.

Selection comes down to three things: shaft diameter, the nature of the load (radial, axial or a combination) and where the unit will operate. The insert seal is what keeps dust and moisture out, so in washdown areas or where fine particles are present, check which seal type is fitted. Installation calls for a flat, clean mounting face, bolts tightened in a cross pattern, and careful alignment so the bearing is not put under stress. Lubrication and correct internal clearance are what keep the assembly running.

Housings from different manufacturers can often be swapped when the flange dimensions, shaft diameter and locking arrangement line up. When you ask for a quote, put the main dimensions and the insert type side by side rather than trusting a similar-looking code. MR Industrial Accessories can help you locate the right equivalent within its range of housings and bearings so the equipment keeps performing as intended.

If you already know the code, send it over WhatsApp or email and we will quote it. Looking for a version you cannot find? Write to us with the model or the shaft dimensions and we will point you to a compatible option. We can also go through the whole assembly and recommend the insert and housing that fit your application.