DODGE F2BZ-SXV-112 piloted flange bearing

DODGE F2BZ-SXV-112 belongs to piloted flange bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for F2BZ-SXV-112 and any equivalents.

The DODGE SXV series piloted flange Y-housing is a ready-to-mount assembly that pairs a cast iron housing with a sealed, pre-lubricated insert ball bearing. It supports rotating shafts where a flanged mounting with piloted centering is required, which helps with alignment and anchoring. MR Industrial Accessories supplies this line for power transmission applications.

The part number breaks down into segments. The F prefix denotes the flange style, and the following digit tells you how many mounting holes the flange has. The BZ letters identify the housing type, while SXV points to the insert series. The trailing number, for example 012, 014 or 106, corresponds to the shaft diameter the unit is assembled for. Reading the code this way lets you pinpoint the exact reference.

You will find these housings on belt conveyors, bucket elevators, mixers, blowers and packaging lines. In humid or dusty settings, such as food processing, cement, tannery and wastewater treatment plants, they offer a sturdy mounting that is straightforward to replace. Because the flange is piloted, it seats against a machined face, which lowers the chance of misalignment and allows unit replacement without pulling the entire shaft.

Selection comes down to shaft diameter, number of flange holes and the sealing your environment demands. Where water or fine dust is present, an insert with contact seals is the better choice; in moderate temperatures, factory lubrication is typically enough. During installation, set the flange on a clean, flat surface, tighten bolts in a cross pattern and check that the shaft turns freely. Good alignment helps prevent vibration and supports bearing life.

Interchangeability among piloted flange Y-housings from different makers hinges on mounting dimensions: shaft diameter, hole spacing, pilot diameter and center height. Two references may share the same shaft size yet differ at the flange, so comparing drawings is the safe approach. If you cannot locate an equivalent, send us the measurements or the original part number and we will point you to a compatible alternative.

MR Industrial Accessories supplies the DODGE brand and also manufactures split plummer block housings, ANSI chains and sheaves in-house. To replace a piloted flange Y-housing, message us on WhatsApp with the F2BZ-SXV number from the nameplate, or with the shaft and flange measurements. We will quote promptly and help you define the option that fits your equipment.