DODGE F2B-SXRAG-104S flange bearing 2 holes
- Brand
- DODGE
- Category
- Bearing housings
- Subcategory
- Y-bearing unit
- Series
- SXR AG
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DODGE F2B-SXRAG-104S belongs to flange bearing 2 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for F2B-SXRAG-104S and any equivalents.
The DODGE SXR AG Y-bearing insert unit is a flange-mounted assembly that pairs an insert bearing with a cast iron housing. It supports rotating shafts where space is tight and alignment needs to stay simple. MR Industrial Accessories LLC supplies this line to plants and workshops across the United States and Latin America.
Reading the code helps you order the right variant. In F2B-SXRAG-104S, the F stands for flange housing, 2B indicates two bolt holes, and 104 gives the shaft size in inches. The SXR AG portion identifies the insert bearing family, including its sealing and locking method. That full number points to a 2-bolt flange unit for a 1 1/4 inch shaft.
You will find these units on belt conveyors, mixers, fans, centrifugal pumps and packaging lines. The flange pattern simplifies installation onto existing plates or frames. Because only two bolts are used, the unit can be mounted or removed without pulling the whole shaft, which shortens maintenance downtime.
Selection comes down to shaft diameter, load type (radial, axial or combined) and the operating environment. The insert seal determines how well the unit handles dust, water and washdown chemicals. During installation, verify that the flange sits flat and the holes line up. Proper lubrication and correct internal clearance help extend bearing life. The inner ring locks to the shaft with set screws.
2-bolt flange units can be interchanged between manufacturers when shaft diameter, hole spacing and center height match. When you request a quote, compare those three dimensions plus the seal type. MR Industrial Accessories LLC can point you to a compatible alternative. The DODGE SXR AG series is a common reference for replacements on imported equipment.
To replace a unit or build a new assembly, send the complete part number by WhatsApp or email to MR Industrial Accessories LLC. We reply promptly and can advise on the variant that fits your application. We can also review dimensions and operating conditions to help you choose.
Dimensions
- Número de producto
- 230434
- Bore
- 1-1/4 in
Frequently asked questions
- What does the designation F2B-SXRAG-104S mean?
- F indicates a flange housing, 2B the number of bolt holes, and 104 the shaft diameter in inches. The SXR AG block identifies the insert bearing series. Use that full part number when requesting the complete unit.
- How do I choose between a flange unit and a pillow block?
- It depends on where you can mount it: a flange unit bolts to a vertical or horizontal face with two holes, while a pillow block sits on a base. Also consider load direction and available space.
- What should I check before mounting the unit?
- Make sure the shaft is clean and free of burrs, the flange rests flat, and the holes align. Align the assembly, tighten the set screws on the inner ring, and lubricate according to the insert type. Poor alignment shortens bearing life.