DODGE F2B-SLX-103 flange bearing 2 holes

DODGE F2B-SLX-103 belongs to flange bearing 2 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for F2B-SLX-103 and any equivalents.

A DODGE SLX Y-bearing insert set into a two-bolt flange housing makes up this mounted unit. Two bolts hold the flange to a flat surface, and the flange locates the assembly so it can carry a rotating shaft. Because the insert's outer ring is spherical, small misalignment between shaft and mounting face is taken up inside the unit. It suits industrial equipment where a pillow block will not fit.

Reading an SLX part number is a matter of splitting it into blocks. Take F2B-SLX-008: F stands for flange, 2B gives both the hole count and the housing style, SLX names the insert series, and the trailing digits give the shaft diameter. The same pattern runs through F2B-SLX-010, F2B-SLX-012 and F2B-SLX-014, where only the numeric suffix moves with size. Other sizes in the family carry the codes F2B-SLX-100, F2B-SLX-102 and F2B-SLX-103. Quoting the full number removes any doubt about which unit is meant.

Typical duties include conveyors, belts, elevators, mixers, blowers and packaging lines. Food, cement and chemical plants use them, as does agriculture, where the flange bolts to a wall or frame to hold a shaft. Water treatment equipment and woodworking machines are other common homes. Where there is no room for a pillow block, the two-bolt flange is often the practical answer.

Selection comes down to shaft diameter, the load the unit will see, and where it has to work. The insert's sealing decides whether it copes with dust, water or repeated washdowns, while lubrication and internal clearance affect how long it lasts. At mounting, check that the support surface is clean and flat and that the bolts are tightened correctly. Getting the alignment right at the start keeps stress off the insert.

Flange mounted units come from several makers, each with its own numbering. Matching is done on dimensions and insert type rather than on the code itself. Replacing an existing housing? Send the shaft dimensions and the hole spacing. Our team will point you to the compatible option for your application.

MR Industrial Accessories LLC supplies the DODGE brand. Send the part number for an SLX series Y-bearing with insert by WhatsApp or email and the team will come back with a quote. If you need a variant outside the examples listed, we can advise on that too.