DODGE F2B-SCMAH-35M flange bearing 2 holes
- Brand
- DODGE
- Category
- Bearing housings
- Subcategory
- Y-bearing unit
- Series
- SCMAH
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DODGE F2B-SCMAH-35M belongs to flange bearing 2 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for F2B-SCMAH-35M and any equivalents.
The DODGE SCMAH series is a 2-bolt flange bearing unit that pairs a cast iron housing with an insert ball bearing. It arrives pre-aligned and pre-lubricated, ready to support rotating shafts on flat surfaces with two bolts. This unit is designed for applications that need secure support, relubrication capability, and straightforward installation without machining the housing.
The part number breaks down into distinct sections. The F stands for the 2-bolt flange housing. The 2B indicates the housing size. SCMAH identifies the insert family and its shaft locking method. The number that follows, as seen in F2B-SCMAH-25M or F2B-SCMAH-55M, specifies the shaft diameter the unit fits. The trailing M denotes the sealing and insert configuration. Together, these elements fully define the unit.
These bearing units are common in belt and roller conveyors, bucket elevators, mixers, screens, fans, and packaging lines. They are also found in food processing, cement, ceramic, meatpacking, and agricultural plants, both on new equipment and as replacements on older machines. The 2-bolt flange is a practical choice when the mounting surface is small or the shaft runs close to a wall or frame.
When selecting a unit, begin with the shaft diameter and the load type. Most conveyor applications involve predominantly radial loads, with some axial load depending on the screw or tensioner. Consider the sealing: in dusty, wet, or washdown environments, a reinforced seal variant is recommended. During installation, place the flange on a flat, clean surface, tighten the bolts in a cross pattern, and check shaft alignment before final tightening. Relubricate the insert according to the duty cycle, taking care not to overfill.
Interchangeability between brands depends on the shaft diameter, the distance between holes, their diameter, and the shaft center height. A unit from another manufacturer with these same dimensions can replace the original, even if the sealing or locking system differs. If space is tight, also compare the housing contour. To find a compatible alternative, send us the old part number or the dimensions you measure on the equipment.
MR Industrial Accessories LLC supplies the DODGE line and also manufactures split plummer block housings, ANSI roller chains, and sheaves. If you need to replace a 2-bolt flange bearing unit, contact us on WhatsApp or by email with the F2B-SCMAH part number and the shaft diameter. Our team will quote promptly and, if needed, suggest the best option for your machine.
Dimensions
- Bore
- 35 mm
Frequently asked questions
- How do I identify the bearing unit I need?
- Note the shaft diameter, the distance between the flange holes, and the height from the shaft center to the support. With these three dimensions and the part number on the old housing, we can quote the equivalent unit.
- Can it be replaced by another brand?
- Yes, if the shaft diameter, hole spacing, and center height match. The insert and sealing may differ between manufacturers, so it is wise to also compare the shaft locking type.
- What maintenance does the insert require?
- It is a relubricatable insert ball bearing. The frequency depends on speed, load, and environment: in dusty or humid areas, shorten the intervals. Also check that the seal is intact and the shaft is not worn.