DODGE F2B-DLMEZ-111-SHCR flange bearing 2 holes

DODGE F2B-DLMEZ-111-SHCR belongs to flange bearing 2 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for F2B-DLMEZ-111-SHCR and any equivalents.

The DODGE DLEZ series two-bolt flange Y-bearing housing with insert bearing is a mounted assembly that pairs a cast iron housing with a ball insert bearing. It arrives pre-aligned and pre-lubricated, ready to support transmission shafts where frontal fastening with two anchoring points is needed. Installation and removal of the shaft are straightforward.

The DLEZ code breaks down into meaningful blocks. The initial letters denote the housing type and shaft diameter; the suffix DLMEZ signals the two-bolt flange variant; the middle number gives the nominal shaft diameter. For instance, F2B-DLMEZ-111-SHCR* uses F2B for the two-bolt flange and 111 for the intended shaft. The trailing asterisk points to a sealing or finish option that should be confirmed at the time of quoting.

These housings appear in belt and screw conveyors, bucket elevators, mixers, blowers, and packaging lines. In food plants, cement works, cold storage, tanneries, and aggregate processing, they operate in dusty, humid, or washdown-heavy conditions. The two-bolt flange makes anchoring to sheet metal or structural frames simple and holds the shaft in a fixed position.

Selection depends on shaft diameter, insert fastening type (set screw, eccentric, or adapter), and sealing. Where water or particles are present, a higher-protection closure is preferable. During mounting, seat the flange on a flat surface, tighten bolts in a cross pattern, and verify shaft alignment before final torque. Factory lubrication is applied, but in service check grease condition and axial play according to operating hours.

Across brands, two-bolt flange housings with insert bearings interchange by shaft dimensions, hole spacing, and flange diameter, not by manufacturer code. If the equipment uses a DLEZ housing, those dimensions and the insert fastening type are what matter. When the original part number does not match the replacement need, we can indicate a compatible alternative.

To proceed, send the part number from the housing or equipment plate, such as F2B-DLMEZ-111-SHCR*, along with the shaft diameter. We will quote the DODGE housing or the best-suited alternative for your mounting and reply promptly.